JVC toledo To Replace an Oven Door, To Adjust an Oven Door Angle, To Change the Oven Door Latch

6.2To Replace an Oven Door

Open the oven door. Support the door and loosen the two screws securing the upper hinge and gasket to the cooker front (Fig.9-9).

nnThe door is heavy, so take care.

Support the door and remove the screw nearest the hinge pin (Fig.9-10). Swing the hinge up and away from the door hinge pin. Lift the door away from the lower hinge and remove.

Reassemble in the reverse order.

6.3To Adjust an Oven Door Angle

The bottom hinge of either oven door can be adjusted to alter the angle of the door (Fig.9-11). Loosen the bottom hinge ￿xing screws and use the notch and a ￿at bladed screwdriver to move the position of the hinge to set the hinge position (Fig.9-12).

Retighten the hinge screws.

6.4To Replace an Oven Door Outer Panel

Move the cooker forwards to gain access to the sides.

Open the oven door slightly and remove the 4 front panel ￿xing screws from the door sides (two each side), (Fig.9-13).

Carefully lift o￿ the outer door panel.

Remove the door handle from the panel by unscrewing the two retaining nuts.

Fit the door handle to the new panel.

Fit the panel to the door. Reassemble in the reverse order.

6.5To Change the Oven Door Latch

Remove the outer door panel (see 6.3). Remove screws ‘B’, which hold the latch assembly to the inner door panel (Fig.9-14). Fit the new catch and reassemble in reverse order. Check the door operation.

6.6To Adjust an Oven Door Catch Keep

Open the oven door, slacken o￿ the locknut at the base of the keep, and screw in or out as required until the required ￿t is obtained. Retighten the locking nut (Fig.9-15).

6.7To Change an Oven Door Seal

Open the oven door. The seal is held in place by small hooks on the rear face. At the corner, pull the seal diagonally away from the door centre until that hook is released (Fig.9-16). Proceed to the next hook and release it in a similar way, and so on. Use force if the hooks are sti￿, as the old seal will be discarded.

When ￿tting the new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door, snapping in each hook in turn.

Centreline of hinge pin Fig.9-11

ArtNo.320-0007 Oven door hinge adjustment 2

Oven door omitted for clarity

Fig.9-12

-0006 Oven door hinge

E￿ect of hinge adjustment – exagerrated for clarity

Fig.9-13

	ArtNo.320-0002a Proplus oven door side screws
Fig.9-14	Fig.9-15
	ArtNo.320-0004 Oven door keep

B

ArtNo.320-0003 Oven door latch

Fig.9-16

ArtNo.320-0005 Oven door rubber seal

35