INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
•The hood support surface must be 135 mm above the bottom surface of the wall units.
•Drill the support with a ø 4,5 mm drill bit, using the drilling template provided.
•Cut a hole ø 125 mm in size on the support surface, using the drilling template provided.
•Fix using the 4 screws 12a (4,2 x 44,4) provided.
CLOSING ELEMENT
•The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose.
12a
125 |
135 |
20
EN |
| 5 |
| 5 |