Zanussi ZGF 7820 Building over a cupboard or drawer, Building over a kitchen unit with door

Page 10

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.

Dimensions are given in mm.

Building over a kitchen unit with door

Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.

1

FO 2563

2

F O

2564

3

FO 2044

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

)• put the seals supplied with the hob, on the edges of the cut out: place them at 8 mm from the front and rear edges of the cut out and at 50 mm from the side edges, as shown in the diagram, taking care that the seals meet without overlapping;

place the hob in the cut out, taking care that it is centred;

fix the hob with the relevant fixing clamps and screws, as shown in the diagram. When the screws have been tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents the ingress of liquids.

10

Image 10
Contents GAS HOB Child Safety Important Safety InformationInstallation ServiceContents Description of the Hob Operation Maintenance and CleaningInserire termocoppie Cast Iron Pan Supports Symptom SolutionSomething Not Working? Ignition electrodeInstructions for the Installer Engineers technical dataProvision for ventilation Important safety requirementsLocation Gas Connection InstallationWhen the HOB is First Installed Cut Out SizeBuilding over a kitchen unit with door BuildingBuilding over a cupboard or drawer Fitting the Hob into the worktopThis HOB Must be Earthed Supply cable replacementElectrical connections Permanent ConnectionIgnitor Switch Ignitor Unit Wiring DiagramFault Finding Preliminary Electrical Systems CheckIgnition System / Gas Ignition Commissioning To adjust the gas ratePressure Testing Conversion from Natural Gas to LPGService and Spare Parts Customer CareEuropean guarantee Page Page Page 35687-8702 11/06