Zanussi BMS 641 - BST 6 manual Installation, Electrical Connection, Technical Data

Installation

The oven must be installed according to the instructions supplied.

This oven must be installed by qualified personnel to the relevant British Standards.

Technical Data

DIMENSIONS	Height	580 mm.
OF RECESS	Width	560-570 mm.
	Depth	550 mm.
DIMENSIONS	Height	320 mm.
OF THE	Width	420 mm.
OVEN CAVITY	Depth	390 mm.
	Oven capacity 53.2 litres

Heating elements rating (230 V)

Ovenelement	1.8 kW
Top element	0.8 kW
Bottom element	1.0 kW
Convection element	2.0 kW
Grill element	1.75 kW
Double Grill element	2.55 kW
ConvectionFan	30 W
OvenLight	25 W
Cooling Fan	25 W
Total Rating (230-240 V)	2.6 kW

Electrical Connection

The oven is designed to be connected to 230-240V (50Hz) electricity supply.

The oven has an easily accessible terminal block which is marked as follows:

Letter L	-	Liveterminal
Letter N	-	Neutral terminal
	-	Earth terminal

THIS OVEN MUST BE EARTHED

Model BMS 641 is provided with a a type H05RR-F connection cable with section 3x1,5 mm2.

Model BST 6 is supplied without connection cable. A suitable one must be fitted to the appliance, according to the following type list:

—H07 RN-F

—H05 RN-F

—H07 RR-F

—H05 VV-F

It is necessary that you install a double pole switch between the oven and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current rules.

The switch must not break the yellow and green earth cable at any point.

Important

After installation and connecting, the cable must be placed so that it cannot at any point reach a temperature of more than 60°C above the ambient temperature.

Before the oven is connected, check that the main fuse and the domestic installation can support the load; and that the power supply is properly earthed.

The manufacturer disclaims any responsibility should these safety measures not be carried out.

20