Zanussi ZBS 862 Cleaning the steam generator, Replacing the Oven Light, Cleaning the water tank

Replacing the Oven Light

Ensure the electricity supply is switched off before carrying out this operation.

The oven bulb has to comply to these features:

a)resistant to temperatures of 300 °C;

b)electric rate: 230 V - 50 Hz;

c)electric power rate: 15 W.;

d)connection type: E 14.

To replace the bulb, proceed as follows (Fig. 15):

☞a) push in and turn the glass lid anticlockwise;

b)remove tha faulty bulb;

c)replace it with a new one;

d)refit the glass lid;

e)switch on the electricity supply.

FO 0287

Fig. 15

Cleaning the steam generator

Cleaning the water tank

Just like in any appliance fed with water (e.g. the iron), is it absoluitely normal that limestone residues form in the water tank.

After having used the oven for steam cooking several times, the limestone residues that settle inside the water tank can cause a reduction of the steam.

If the red pilot light that indicates the need of a cleaning cycle comes on, this means that a certain quantity of limestone has settled in the water tank and that a thorough cleaning of the steam generator is necessary.

In that case proceed as follows:

☞- Set the water tank exhaust-pipe ready for use. Fit the connector with hexagonal nut (Figure 16, letter "A") to one of the edges of the pipe.

-Open the oven door (Fig. 17) and fit the connector (A) into the exhaust-valve (C) located in the lower left hand corner of the oven cavity frame.

-Place the free edge of the pipe into a vessel, then turn the pipe connector "A" anticlockwise to open the exhaust-valve. Water will flow out the water tank.

Fig. 16

Fig. 17

74