12Additional information

Specifications

Amplifier section

Continuous average power output of 120 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.2 %** total harmonic distortion (front).

Continuous Power Output (20 Hz to 20 kHz, 8 Ω, 0.09 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W

Continuous Power Output (1 kHz, 6 Ω, 1.0 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W

Total harmonic distortion . . . . . . . . . . . . . . . . . . . . . . . 0.05 % (20 Hz to 20 kHz, 100 W, 8 Ω)

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Audio Section

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/47 kΩ Frequency Response (LINE) . . . . . . 5 Hz to 100 000 Hz dB Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/2.2 kΩ Tone Control

BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz) LOUDNESS . . . . . . . . . . +4 dB / +2 dB (100 Hz/10 kHz)

(at volume position –40 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .103 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .83 dB

FM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Usable Sensitivity . . . . . . . Mono: 13.2 dBf, IHF (1.3 µV/75 Ω) 50 dB Quieting Sensitivity . . . . . . . . . . . . . . . Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio . . . . . . . . . . . . Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf)

Distortion . . . . . . . . . . . . . . . . . . . . . . . .Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity . . . . . . . . . . . . 60 dB (400 kHz) Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . 40 dB (1 kHz) Frequency Response . . . . . . . . . . . . 30 Hz to 15 kHz ± 1 dB Antenna Input . . . . . . . . . . . . . . . . . . . . . . . .75 Ω unbalanced

AM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . . 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna) . . . . . . . . . . . . . . . . 350 µV/m Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power Requirements . . . . . . . . . . . . . . . . . . . AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . 490 W, 650 VA In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W AC Outlet . . . . . . . . . . . . . . . . . . . . . . (switched) 100 W MAX. Dimensions . . . . . . 420 (W) mm x 173 (H) mm x 465 (D) mm

(16 9/16 (W) in. x 6 13/16 (H) in. x 18 5/16 (D) in.) Weight (without package) . . . . . . . . . . . .15.0 kg (33 lbs 1 oz)

Furnished Parts

Setup microphone (for Auto MCACC setup) . . . . . . . . . . . . 1 AA/IEC R6P dry cell batteries . . . . . . . . . . . . . . . . . . . . . . . 2 Remote control unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

•Specifications and the design are subject to possible modifications without notice, due to improvements.

Composite Video / S-Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Ω Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Ω Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . . 5 Hz to 10 MHz

Component Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Ω Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Ω Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . 5 Hz to 100 MHz

Cleaning the unit

•Use a polishing cloth or dry cloth to wipe off dust and dirt.

•When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

72

En

Page 71 Page 73
Page 72
Image 72
Pioneer VSX1017TXV manual Additional information Specifications, Cleaning the unit
Page 71 Page 73

VSX1017TXV specifications

The Pioneer VSX-1017TXV is a versatile and powerful home theater receiver that caters to audiophiles and casual listeners alike. This 7.1-channel receiver is known for its ability to deliver immersive audio experiences, making it an excellent choice for anyone looking to enhance their home entertainment setup.

One of the main features of the VSX-1017TXV is its robust power output. With 100 watts per channel, it is equipped to drive a wide range of speakers while providing clear and dynamic sound. The receiver supports various surround sound formats, including Dolby Digital EX, DTS-ES, and Dolby Pro Logic IIx, allowing users to fully immerse themselves in the action of their favorite movies and games.

Another key characteristic of the Pioneer VSX-1017TXV is its advanced HDMI connectivity. With multiple HDMI inputs, the receiver can easily integrate with modern devices such as Blu-ray players, gaming consoles, and streaming devices. The unit supports high-definition audio formats like Dolby TrueHD and DTS-HD Master Audio, ensuring that users experience their media in the best possible quality.

The receiver also features Pioneer's MCACC (Multi-Channel Acoustic Calibration System) technology. This innovative system automatically analyzes the acoustics of the room and calibrates the audio output accordingly. As a result, users can enjoy optimal sound quality tailored to their specific listening environment without the need for extensive manual adjustments.

In addition to its audio capabilities, the VSX-1017TXV includes a variety of practical features for everyday use. The on-screen display simplifies navigation through menus and settings, while its remote control allows for easy operation from across the room. The receiver supports multi-zone functionality, enabling users to send audio to different areas of the house simultaneously.

With a sleek design that fits seamlessly into any home entertainment setup, the Pioneer VSX-1017TXV combines style with performance. Its solid build quality and user-friendly interface make it an ideal choice for those looking to elevate their home theater experience. Overall, the VSX-1017TXV stands out as a strong contender in the home audio market, delivering impressive sound and advanced features.
Top Page Image Contents