10Using other functions
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.
|
|
| |
CD | iPod | TUNER | RECEIVER |
| SLEEP | SBch | ANALOG |
|
|
| ATT |
| SR+ | DIMMER | MIDNIGHT/ |
|
|
| LOUDNESS |
| DIALOG E | PHASE | S.RETRIEVER |
DACCESS
•Press RECEIVER then press DIMMER repeatedly to change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. Use the front panel controls to do this.
• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6 Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8 Ω or more.
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the front panel TONE button,
press and hold STANDBY/ON for about three seconds.
The display shows RESET?.
3Press the front panel ENTER button. The display shows RESET OK?.
4Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
•Note that all settings will be saved, even if the receiver is unplugged.
56
En
