Cleaning the oven door
The following instructions are relevant to the oven door as it is supplied by the Manufacturer.
If the oven door has been reversed, please note that the references to the right and left side have to be switched.
Figure 1. With the right hand, hold the aluminium slotted bar (“A”) while pulling off the inner glass support “B” with the left hand. Push the support towards the right to release it and then lift it up.
Figure 2. Remove the aluminium slotted bar “A” from support “C”.
Figure 3. Hold firmly the inner glass “D” with the left hand and pull the support “C” off from its original position.
Make sure that glass “D” is firmly held to prevent it from falling down.
Figure 4. Hold tighly the inner glass “D” with both hands and remove it from its original position by sliding it up.
After removing the inner glass, clean the oven door and the glasses.
We recommend to clean the oven door using only a wet sponge and dry it up after cleaning with a soft cloth. Never use steel wool, acids or abrasive products as they can damage the oven surface.
After cleaning, place the inner glass “D” back in its original position.
To correctly mount the inner glass “D” (with stripes
along the sides) the surface marked with stripes has to face the oven door in a way that, when touching the surface on sight, the light roughness of the
After placing the inner glass back, insert support “C” in its position and, then:
A
B
Figure 1
A
C
Figure 2
C
D 
Figure 3
D
Figure 4
16