Toshiba RAS-13JKVP-E, RAS-13JAVP-E, RAS-10JKVP-E, RAS-10JAVP-E owner manual Special Maintenance

Models: RAS-10JAVP-E RAS-10JKVP-E RAS-13JKVP-E RAS-13JAVP-E

1 30
Download 30 pages 57.91 Kb
Page 21
Image 21
SPECIAL MAINTENANCE

SPECIAL MAINTENANCE

Attaching the Zeolite-plus filter and Zeolite-3G filter

After installing the air conditioner, attach the supplied Zeolite-plus filter and Zeolite-3G filter.

Preparation:

1.Turn off the air conditioner using the remote control.

INFORMATION

It is recommended that you replace the filters once about every six years.

Deodorizing performance will drop when there are severe stains due to extended periods of usage such as due to tar accumulation from cigarette smoke.

1Open the air inlet grille.

Lift up the air inlet grille until it clicks into place.

2Take off the air filter from the left side.

Grasp the left and right handles of the air filter and lift up slightly and then pull downward to remove the filter from the filter holder.

3Attach the Zeolite-plus filter and Zeolite-3G filter to the front panel.

When attaching new filters, remove the Zeolite-plus filter and Zeolite-3G filter from the bag, and then insert the filters with the Zeolite-plus filter on the top.

4Attach the air filter, and then close the air inlet grille.

Cleaning the Zeolite-plus filter and Zeolite-3G filter

Clean the filters when you clean the dust collecting unit. (Clean approximately once every six months.)

Preparation:

1.Turn off the air conditioner using the remote control.

1Open the air inlet grille.

Lift up the air inlet grille until it clicks into place.

2Grasp the left and right handles of the air filter and lift up slightly and then pull downward to remove the filter from the filter holder.

3Remove the Zeolite-plus filter and Zeolite-3G filter from the front panel.

4Wash the Zeolite-plus filter and Zeolite-3G filter in water, and then drain.

If the filters are dirty with dust and dirt, use a vacuum cleaner to remove the dirt before washing with water. Also, be sure to always use clean water when washing. If dirty water is used, the debris in the water can adhere to the filters.

Do not rub the filter surface.

In the final of the water washing, be sure to always rinse the filter with clean water.

If the filter is particularly dirty, add a neutral detergent at the standard concentration and then rinse with clean water until there are no more soap bubbles.

Drain gently after washing with water.

5Allow the Zeolite-plus filter and Zeolite-3G filter to dry in the sun.

• It takes about six hours for the filters to dry in direct sunlight.

6Attach the air filter, and then close the air inlet grille.

Items sold separately

Zeolite-plus filter (RB-A607DE) Zeolite-3G filter (RB-A608DE)

EN

20

Page 21
Image 21
Toshiba RAS-13JKVP-E, RAS-13JAVP-E, RAS-10JKVP-E, RAS-10JAVP-E owner manual Special Maintenance