NAMES AND FUNCTIONS OF INDICATORS ON REMOTE CONTROL
Display
All indicators, except for the clock time indicator, are displayed by pressing the 
button.
aTransmission mark
This transmission mark (
) indicates when the remote control transmits signals to the indoor unit.
b Mode indicator | c | adbhj | |
Indicates the current operation mode. | |||
|
| ||
(AUTO: Automatic control, A: Auto changeover control, : Cool, : Dry, |
|
| |
: Heat) |
|
| |
c Temperature indicator |
|
|
Indicates the temperature setting (17°C to 30°C). d Air purifying indicator
Shows that the electrical air purifying operation is in progress. e FAN speed indicator
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW 
,
LOW+ | , MED | , MED+ | , HIGH | ) can be shown. |
|
|
|
|
| ||
Indicates AUTO when the operating mode is either AUTO or | : Dry. | i g | e | f | |||||||
f TIMER and clock time indicator |
|
| • In the illustration, all indicators are shown | ||||||||
The time setting for timer operation or the clock time is indicated. | |||||||||||
for purposes of explanation. During | |||||||||||
The current time is always indicated except during TIMER operation. | |||||||||||
operation, only the relevant indicators are | |||||||||||
g Hi POWER indicator |
|
|
| ||||||||
|
|
| shown on the remote control. |
| |||||||
Indicates when Hi POWER operation starts. |
|
|
| ||||||||
|
|
|
|
|
|
| |||||
Press the Hi POWER button to start and press it again to stop operation. |
|
|
|
|
| ||||||
h | (MEMORY) indicator |
|
|
|
|
|
|
|
| ||
Flashes for 3 seconds when the MEMO button is pressed during operation. |
|
|
|
|
| ||||||
The |
| mark is shown when holding down the button for more than 3 seconds |
|
|
|
|
| ||||
|
|
|
|
|
| ||||||
while the mark is flashing. |
|
|
|
|
|
|
|
| |||
Press another button to turn off the mark. i ECO indicator
Indicates when the ECO is activated.
Press the ECO button to start and press it again to stop operation.
jA. B change indicator remote control
Press the CHECK point and FIX button at the same time to change the remote control setting from “A” to “B”. (Priority is given to the “A” setting.)
The
PREPARATION AND CHECK BEFORE USE
Loading the remote control batteries | • Slide off the cover while pressing the sides. |
aRemove the cover, and insert the batteries.
b Press the RESET button. | • Battery replacement |
The clock indicator flashes. | Be careful not to reverse the (+) position and the |
Adjust the clock. | position. |
Reattach the cover. |
|
ENGLISH
FRANÇAIS
DEUTSCH
ITALIANO
ESPAÑOL
NEDERLANDS
Batteries
•To replace the batteries, use two new batteries (AAA type).
•The batteries will last about one year under normal usage.
•Replace the batteries if there is no receiving beep from the indoor unit or when the air conditioner cannot be operated using
the remote control.
• To avoid malfunctions due to battery leakage, remove theb batteries when not using the remote control for more than one
month.
HiPOWER ECO MEMO
1.3.5.9H
SWING FIX FAN SLEEP
CLR |
| SET |
ON | OFF | FILTER |
CLOCK |
| |
|
| |
RESET |
|
|
CHECK |
|
|
PORTUGUÊS
5 | EN |
ǼȁȁǾȃǿȀǾ
