Hi POWER OPERATION
High power (Hi POWER)
•The Hi POWER (high power operation) mode automatically controls room temperature, air flow and the operation mode so that the room is quickly cooled in summer and warmed in winter. () see page 16.)
Setting Hi POWER mode
aHi POWER button
Press the Hi POWER button. The Hi POWER mark on the remote control is shown.
Canceling Hi POWER mode
aHi POWER button
Press the Hi POWER button once again.
The Hi POWER mark on the remote control turns off.
CAUTION
The Hi POWER mode cannot be activated during DRY operation and when the ON TIMER operation is activated.
a
PAP AUTO
TEMP
MODEPRESET
HiPOWER ECO MEMO
1.3.5.9H
SWING FIX FAN SLEEP
CLR |
| SET |
ON | OFF | FILTER |
CLOCK |
| |
|
| |
RESET |
|
|
CHECK |
|
|
ENGLISH
FRANÇAIS
DEUTSCH
TIMER OPERATION
ON timer and OFF timer
Setting the ON Timer
a ON ON button
Press the ON ON button. Set the timer to the desired time.
Each time the ON button is pressed, the time changes in ten minute increments.
Holding down the ON button changes the time in one hour increments.
b SET | SET | button |
| PAP | TEMP | AUTO | |
|
|
| |||||
|
|
|
|
|
|
| |
Press the SET SET | button to set the timer. | MODE |
|
| PRESET | ||
The timer time is displayed, and the timer starts. |
|
| |||||
|
|
|
| ||||
c CLR | CLR | button |
|
|
|
|
|
Press the CLR CLR | button to cancel the timer setting. | HiPOWER | ECO | MEMO | |||
|
|
|
| ||||
Setting OFF Timer |
|
|
|
| 1.3.5.9H | ||
b | SWING | FIX | FAN | SLEEP | |||
|
|
| CLR |
|
| SET | |
a OFF | OFF button | c |
|
| |||
CLOCK | ON | OFF | FILTER | ||||
|
|
| a | RESET |
|
|
|
|
|
|
| CHECK |
|
| |
Press the OFF OFF | button. |
|
|
|
|
Set the timer to the desired time.
Each time the OFF button is pressed, the time changes in ten minute increments.
Holding down the OFF button changes the time in one hour increments.
b SET SET | button |
|
Press the SET SET | button to set the timer. | |
The timer time is displayed, and the timer starts. | ||
c CLR CLR | button |
|
Press the CLR CLR | button to cancel the timer setting | |
. |
|
|
CAUTION
•When you select timer operation, the remote control automatically transmits the timer signal to the indoor unit at the specified time. Therefore, keep the remote control in a location where it can transmit the signal to the indoor unit properly.
• If you do not press the SET SET button within 30 seconds after setting the time, the setting will be cancelled.
Once you select timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions as if you pressed the ON or OFF button of the remote control.
You cannot set the timer when the clock display is flashing.
Follow the instructions in the section “Setting the clock” on page 6 to set the clock, and then set the timer.
11 | EN |
ITALIANO
ESPAÑOL
PORTUGUÊSNEDERLANDS
ǼȁȁǾȃǿȀǾ