Zanussi ZYB992 Cleaning the door gasket, Cleaning the oven door, End time for Pyrolytic cleaning

Page 16

Cleaning the door gasket

Regularly do a check of the door gasket. The door gas- ket is around the frame of the oven cavity. Do not use the appliance if the door gasket is damaged. Contact the Service Centre.

To clean the door gasket refer to the general informa- tion about the cleaning.

Pyrolytic cleaning

Warning! The appliance becomes very hot. There is the risk of burns.

Important! Do not use Pyrolytic cleaning function and the hob at the same time (if it is installed with the appliance). It can cause a damage to the appliance.

Before Pyrolytic cleaning:

1.Remove all removable parts from the appliance.

2.Remove the worst of the dirt manually.

3.Close the oven door correctly.

Using the Pyrolytic cleaning

1.Press again and again until the display shows .

The display shows PYRO 1 or PYRO 2.

In 3 seconds the display shows a message to re- move all removable parts from the appliance.

2. While Duration

flashes, press

or

to set the

duration for the Pyrolytic cleaning:

 

 

2:00 for a low degree of dirt

2:30 for a high degree of dirt.

3.Press to start the Pyrolytic cleaning.

The bars on the symbol come on one by one to show that the temperature in the appliance increases.

When the appliance is at the preset temperature, the door

locks and the display shows .

When the Pyrolytic cleaning is completed, the display shows the time of day. The oven door is locked. When the appliance cools down, an acoustic signal sounds and the door unlocks.

To stop the pyrolytic cleaning at any time, press

.

End time for Pyrolytic cleaning

You can set the end time for Pyrolytic cleaning with the clock function End .

16

1.Do again step 1, 2 and 3 from above procedure.

2.Press .

3.The display shows an arrow and the symbol . The display shows the time for the end of Pyrolytic cleaning.

4. Press or to adjust the time for the end of the Pyrolytic cleaning.

Oven lamp

Warning! Be careful! There is the risk of electrical shock!

Before you change the oven lamp:

Switch off the oven.

Remove the fuses in the fuse box or switch off the cir- cuit breaker.

Put a cloth on the bottom of the oven for protection of the oven light and glass cover.

1.Turn the glass cover anti-clockwise to remove it.

2.Clean the glass cover.

3.Replace the oven light bulb with applicable 300°C heat-resistant oven light bulb.

Use the same oven lamp type.

4.Install the glass cover.

Cleaning the oven door

The oven door has four panels of glass. You can remove the oven door and the internal panels of glass to clean them.

The oven door can close if you try to remove the panels of glass before you remove the oven door.

Removing the oven door and the glass panels

1 Open the door fully

2 Lift and turn the levers

and hold the two door

on the two hinges.

hinges.

 

Image 16
Contents Oven ZYB992 Contents Safety informationCare and cleaning Electrical connectionUse Appliance must be earthedPyrolytic cleaning Service centreRisk of fire Oven lampProduct description Before first useDaily use Pre-heatingDisplay Sensor Field FunctionSetting the oven function Touch controlsDigital display Oven functionsHeat indicator Clock functionsRapid Heat-up function Residual Heat functionPreset cooking time Preset temperatureAutomatic programmes Using the accessories Additional functionsHelpful hints and tips CakesBread and Pizza Apple cake Apple pie Strudel Jam-tart Fruit cakeWhite bread Rye bread Bread rolls Pizza Scones 190 200Flans MeatFish GrillingQuantity Pieces GrillingCare and cleaning Thermal grillingPizza Information on acrylamidesCleaning the door gasket Cleaning the oven doorEnd time for Pyrolytic cleaning Before you change the oven lampInstalling the door and the glass panels ProblemWhat to do if… Possible causeInstallation Problem Possible causeElectrical installation Total powerEnvironment concerns Cable892940742-B-422010