Door reversibility
1.Unplug the appliance from the power supply before carrying out the following operations.
2.Pull off the ventilation grill (D).
3.Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side.
4.Remove the bottom hinge (E) by unscrewing its three fixing screws.
5.Remove the freezer door by releasing it from the middle hinge (H).
6.Unscrew the middle hinge.
7.Remove the fridge door by releasing it from the top hinge pin (A).
8.Remove the pin and the washer (A+B) from the top hinge (C), then mount these on the opposite side.
9.After having removed the plugs which must be fitted on the other side, refit the fridge door.
10.Replace the middle hinge to the left hand side.
11.Replace the freezer door.
12.Using a 10 mm spanner, unscrew the hinge pin
(E)and reassemble it on the opposite side of the hinge.
13.Refit the bottom hinge (E) on the opposite side by of the appliance using the screws previously removed.
14.Refit the ventilation grill (D) to the base of the cabinet.
15.On the side where the handle is to be fitted, push in the blanking cover caps to free the new holes. Remove the handles and refit them on the opposite side. Cover the holes left open with the plugs contained in the documentation pack.
The doors can be aligned by adjusting both the middle and top hinges.
The middle hinge can be adjusted horizontally, after having slackened the two screws.
The top hinge is adjusted by slackening the nut with a 10 mm spanner and then proceeding as shown in the figure.
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier on a low setting.
| E | |
F | E | |
F | ||
| ||
| D | |
| F | |
PR18 |
|
C
B
A
D736 |
D737 |
H |
17