7.Connect the plug to the mains socket.
8.Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
Technical data
2.If necessary, adjust the door. Refer to "Installation".
3.If necessary, replace the defective door gaskets. Con- tact the Service Force Center.
Dimension
Height
Width
Depth
Rising Time
ZRB632FS
1750 mm
595mm
632mm
16h
ZRB634FS
1850 mm
595mm
632mm
18h
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
Installation
Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appliance:
Climate | Ambient temperature |
class |
|
SN | +10°C to + 32°C |
N | +16°C to + 32°C |
ST | +16°C to + 38°C |
T | +16°C to + 43°C |
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. En- sure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
min.100 mm |
|
A | B |
20 mm |
|
Electrical Connection
Caution! Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
Warning! This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
9