Replacing the lamp

Problem	Possible cause
Water flows on the ground.	The melting water outlet does not flow
	in the evaporative tray above the com-
	pressor.
There is too much frost and ice.	Products are not wrapped properly.
	The door is not closed correctly.
	The Temperature regulator may be set
	incorrectly.
The temperature in the appliance	The Temperature regulator may be set
is too low.	incorrectly.
The temperature in the appliance	The Temperature regulator may be set
is too high.	incorrectly.
	The door is not closed correctly.
	The product temperature is too high.

	Many products are stored at the same
	time.
The temperature in the refrigera-	There is no cold air circulation in the
tion is too high.	appliance.
The temperature in the freezer is	Products are too near to each other.
too high.
The appliance does not operate.	The appliance is switched off.
	The mains plug is not connected to the
	mains socket correctly.
	The appliance has no power. There is
	no voltage in the mains socket.

The lamp does not work.	The lamp is defective.

Attach the melting water outlet to the evaporative tray.

Wrap the products better.

Refer to "Closing the door".

Set a higher temperature.

Set a lower temperature.

Refer to "Closing the door".

Let the product temperature decrease to room temperature before storage.

Store less products at the same time.

Make sure that there is cold air circula- tion in the appliance.

Store products so that there is cold air circulation.

Switch on the appliance.

Connect the mains plug to the mains socket correctly.

Connect a different electrical appliance to the mains socket. Contact a qualified electrician.

If your appliance is still not working properly after making the above checks, contact the After Sales Centre.

Caution! Disconnect the plug from the mains socket.

1.Remove the screw from the lamp cov-

cover.

4.Replace the lamp with one of the same power (the maximum power is shown on the light bulb cover).

5.Install the lamp cover.

6.Tighten the screw to the lamp cover.