Zanussi ZRB632FS Rear spacers and levelling, Removing the shelf holders, Door reversibility

Page 10

12

3

4

5

socket is a serious safety (shock) hazard. Ensure that it is disposed of safely.

Rear spacers and levelling

2

1

3

Important! The wires in the mains lead are coloured in accordance with the following code:

 

Green and Yellow:

Earth

1

In the bag with the docu- mentation, there are two spacers which must be fit- ted as shown in the figure. Slacken the screws and in- sert the spacer under the screw head, then tighten again the screws.

When placing the appli- ance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front.

 

Brown:

Live

3

 

Blue:

Neutral

5

As the colours of the wires in the mains lead of this ap- pliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

1.Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow.

2.Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black.

3.Connect the wire coloured brown to the terminal ei- ther marked with the “L“ or coloured red.

4.Check that no cut, or stray strands of wire is present and the cord clamp 4 is secure over the outer sheath.

5.Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

6.Switch on the appliance.

The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug sup- plied, a 13 amp ASTA approved (BS 1362) fuse must be used.

Warning! A cut off plug inserted into a 13 amp

10

Removing the shelf holders

Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation.

To remove them proceed as follows:

1. Move the shelf hold- ers in the direction of the arrow (A).

2. Raise the shelf from the rear and push it forward until it is freed

(B).

3.Remove the retainers

(C).

Door reversibility

Warning! Before carrying out any operations, remove the plug from the power socket.

Important! To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations.

Image 10
Contents ZRB632FS ZRB634FS Contents Safety informationService Care and cleaningInstallation Daily UseFirst use OperationDaily use Helpful hints and tips Hints for freezing Care and cleaningPeriodic cleaning Hints for storage of frozen foodDefrosting of the freezer What to do if…Defrosting of the refrigerator Appliance is noisy Compressor operates con- tinuallyReplacing the lamp Technical data InstallationRemoving the shelf holders Rear spacers and levellingDoor reversibility Remove the doors Environmental concernsUnscrew the lower hinge b1 200372466-00-02022009