Zanussi ZPC 428 DM manual Fitting door panels, Building-in

Left hand door opening

Remove the screws and the upper pivots. Lift off the upper door. Remove the middle hinge (A-Fig. 2) and fix it to the other side, after having removed the little caps which cover the holes and which must be refitted on the opposite side. Replace the upper door and fix the screw and the upper left pivot into place. Straighten the safety washer (4) of the lower right hinge (Fig. 2a). Remove the screw and the pivot (6-Fig. 2a). For safety reasons, bend the safety washer located under the left hinge (Fig. 3), by using a suitable tool (for ex. a screwdriver). Remove the door’s top right hinge (3-Fig. 2a).

Fig. 3

6

4

5

D563

Fitting door panels

To fit the door panel, proceed as follows:

Loosen the screws fixing the side frame (Fig. 4);

loosen all the other screws fixing the door frame;

insert the panel from the side on which the frame has been removed and push it through;

refit the frame on the door again and tighten all the screws.

Note:

The panel size should be 1-2 mm lower than the door; the maximum panel thickness should be 4 mm.

Fig. 4

D243

Building-in

The housing dimensions should be as follows:

Height	1580 mm
Minimum depth	550 mm
Minimum width	560 mm

Cooling air comes in through the ventilation grid at the bottom of the appliance. To ensure air circulation, leave a ventilation gap at the back of the appliance, having the following dimensions:

depth: 50 mm, width: 540 mm (Fig. 5).

A similar gap must also be left in the top of the kitchen furniture.

Fit the appliance into the housing and secure it with the the top frame screws (Fig. 5a) and the bottom hinge screws (Fig. 5a).

	Fig. 5
50	540
P
L	H
D592
	Fig. 5a
D606
Note

After having installed the appliance in the appropriate space and having adjusted the opening direction of the doors as required, remove block (3- Fig. 2a) which is fitted on the side opposite the hinge.

13