Grizzly H6069 instruction manual Operations, Filling Reservoir, Disconnect from the Power Source

OPERATIONS

Filling Reservoir

Reduce the risk of electrocution by keeping all connections dry and off the ground. DO NOT touch plugs with wet hands. Failure to follow these warning could result in seri- ous injury.

Be sure the cord is positioned with a “drip loop” below the level of the outlet as shown above. This prevents water from running down the cord and into the outlet. Instead the water will drip to the floor at the “drip loop” on the cord.

To fill the water reservoir:

1. DISCONNECT FROM THE POWER

SOURCE.

2.Loosen the tool rest adjustment lock handles and move the tool rest away from the sharpening stone.

3.Fill the water reservoir. See Figure 2

Fill Here

Figure 2. Tool rest moved away from

sharpening wheel.

4.With dry hands and a dry plug, con- nect the wet sharpener into the power source.

5.Run the wet sharpener for one minute to properly wet the stone.

6.With dry hands and a dry plug, discon- nect the saw from the power source.

7.Refill the water reservoir until full and return the tool rest to the desired loca- tion.

NOTE—It is important to keep the wheel well lubricated while sharpening. Unplug and refill machine as needed to maintain an appropriate water level.

-6- Model H6069 Wet Sharpener