9.Twist the feed screw so the vertical slot on the feed screw aligns with the vertical shaft on the inside of the grinder head.
10.Slide the assembly into the grinder head. Use the pin on the side of the barrel as a guide into the slot. Note– The vertical slot on the back of the feed screw must align with the vertical shank inside the grinder head (Figure 5).
Figure 5. Inserting assembly
11.Tighten the locking knob to secure the assembly to the grinding head.
12.Set the hopper into the throat of the grinder head (Figure 6).
Figure 6. Inserting hopper
Controls
ON/OFF and REVERSE Switch (Figure 6):
Figure 6. Switch location
1.Turn the switch to the right to turn the motor ON.
2.Turn the switch to the center position to turn the motor OFF.
3.The REVERSE feature is handy for clearing the cutting blade and cut- ting plate of meat. Turn the switch to the REVERSE position to REVERSE the direction of the cutting blade.
WAIT UNTIL GRINDER HAS COME TO A COMPLETE STOP BEFORE REVERSING. The motor will only turn in reverse as long as the REVERSE switch is held in position.
Model H6247 Meat Grinder |