Assembling Grinding
Head
1.Loosen the locking ring, and remove the barrel from the grinding motor housing.
2.Unscrew the lock ring and remove the cutting plate, cutting blade, and feed screw. Thoroughly sanitize the grinder head and throat, barrel, cut- ting plates, cutting blade, feed screw, lock ring, locking knob and hopper (refer to Proper Sanitization on page 9).
3.Before proceeding with assembly, wipe down the outside surface of grinder motor housing with a sanitized cloth.
4.After cleaning, assemble the grinder head by inserting the feed screw into the barrel with the vertical slot on the shaft projecting through the back of the barrel (Figure 2).
Barrel
Feed Screw
Figure 2. Feed screw installation
5.Carefully slide the cutting blade on the square shaft on the front of the feed screw (Figure 3).
Figure 3. Cutting blade installation
6.Choose one of the two cutting plates.
7.Slide the cutting plate over the shaft and the locking pin located at the bot- tom the barrel (Figure 4 ).
Locking Pin
Figure 4. Cutting plate installation
8.Screw the locking ring on the barrel clockwise to secure the assembly. Note–Use mild pressure to tighten. Overtightening can cause the cut- ting blade to bind against the cutting plate.
Model H6247 Meat Grinder |