Grizzly G9922 owner manual Table Tilt, 0º Table Stop, To tilt the table, To set the 0 stop

Table Tilt

The table on the Model G9922 can be tilted up to 45° for sanding beveled edges.

To tilt the table:

1.DISCONNECT SANDER FROM POWER!

2.Loosen the two lock knobs, located on each side of the table tilt assembly (Figure 22).

Table Tilt Lock Knobs

Figure 22. Table lock knobs.

3.Adjust the table to the desired angle using the angle gauge as a guide. Once the angle is set, tighten both lock knobs (Figure 23).

Angle Gauge

Figure 23. Adjusting angle.

Note: The angle gauge is only for approximate angle measurements. For precise angle set- ting, use an adjustable angle finder between the table and sanding drum.

-22-

0º Table Stop

The Model G9922 has a 0° table stop that lets you easily set the table tilt back to 0º for sanding square edges.

To set the 0° stop:

1.DISCONNECT SANDER FROM POWER!

2.Loosen the jam nut and turn the stop bolt several turns clockwise (Figure 24).

Stop Bolt

Jam Nut

Stop Bracket

Figure 24. 0° stop.

3.Use a square to set the table perpendicular to the sanding drum, then securely tighten both lock knobs (Figure 25).

Square

Lock Knob (x2)

Figure 25. Squaring table to drum.

4.Turn the stop bolt until it just touches the bot- tom of the table. Then, without turning the stop bolt, tighten the jam nut against the stop bracket.

G9922 (Mfg. since 12/01)