Hunter Fan 83006 manual D11, D12, D13, D15, Existing Construction accessible only from below

Existing Construction – accessible only from below

D11 EXISTING FAN

D12

F

Remove an existing fan and check to make sure the open-	Move the housing into position above the ceiling.
ing is large enough to accommodate the new motor hous-
ing (9”x 9.75”).

D13

Route wires through strain relief.

D14

2

1

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

D15

F

Install the housing flush with the sheetrock and secure by

tightening the pre-loaded screws into the joist.

41954-01 3/13/2006

HF0022_Eng_3.13.06.indd 15

15

3/12/06 6:03:25 PM