•Put the filter holder and the filter in the dishwasher every 2 months.
WATER TANK
•If left unused for long periods it is advisable to replace the water in the tank with fresh water and to empty the boiler by pressing the coffee button (ref.4) repeatedly.
•Clean the water tank (ref.27) periodically to remove any
•The water tank is
•If Brita decalcifying filters are used it is advisable to replace the filter every 2000 espresso coffees or at least every two months.
•Ensure that the plastic tube is placed inside the water tank so the water is fed into the machine.
BOILER CLEANING FREQUENCY
•Like any other appliance that uses water, it is perfectly normal for
boiler of the coffee machine.
-It is advisable to clean the boiler every six months as follows:
-Fill the tank with 1.5l water and add half a glass of vinegar or citric acid.
-Press the coffee button repeatedly so that the water/vinegar solution comes through a little at a time until the tank is empty.
-Repeat the operation until clean water comes through (with no trace of
-Fill the tank with cold water and again press the coffee button repeatedly to rinse the boiler.
-The machine is now ready for use.
CHANGING THE LIGHT BULB
•If the light bulb fails, ensure that the light housing is cool before replacing the bulb. To
replace the bulb proceed as follows:
-Disconnect the machine from the electricity supply.
-Pull down the glass retaining ring and glass.
-Pull out the bulb and replace with one of the same characteristics making sure that the glass of the new bulb is not touched by hand.
-Carefully wipe the new bulb with a soft cloth.
-Refit the glass and glass retaining ring and reconnect the machine to the electricity supply. The bulb is a 20 watt, 12 volt halogen bulb with a
SOMETHING NOT WORKING
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
If the machine does not operate, check that:
−The machine is connected to the electricity supply.
−The water tank is not empty.
If the power supply cable is damaged or for any other maintenance operation please contact your local Zanussi Service Centre.
TECHNICAL ASSISTANCE AND SPARE PARTS
If the problem persists after carrying out the check- ups indicated in the previous chapter, contact your nearest authorised Technical Assistance centre. Always describe the fault and give the model (Mod.), product number (Prod. no.) and serial number (Ser. No.) of the appliance which are indicated on the identification plate of the coffee machine.
8