Zanussi ZKG6040 Pressure testing, Checking the grill, Checking the hob, Checking the top oven

Page 39

4.The stability chain anchor point on the appliance is shown below.

Pressure testing

1.The Rapid injector is used as a pressure test point.

2.Connect the pressure gauge to the Rapid injector.

3.Check the supply pressure by turning the Rapid burner on and one other hotplate burner full on and light the appropriate burner. The pressure should be 20mbar.

4.Turn off the taps, disconnect the pressure gauge.

5.Check operation of each hotplate burner.

Checking the grill

1.Place the grill pan containing the grid, with the handle attached, into the grill compartment. Light the grill burner by turning the grill tap full on and pressing the ignition button on the fascia panel. As soon as the burner is lit the button can be released.

Checking the hob

1.Lift the lid. Fit the burner crowns and caps ensuring that they are correctly seated. Fit the pan supports.

2.Check each of the hob burners in turn by turning the hob tap to its full on position and pressing the ignition button. As soon as the burners are lit the button can be released.

Checking the lid shut-off device

1.Lift the lid

2.Turn one hotplate tap to its full on position and push the ignition button.

3.Close the lid. There should now be no gas supply to the hotplate and the burner will go out.

4.Turn off the hotplate and lift the lid. The gas supply should now be restored to the hotplate, when the tap is turned on.

Checking the top oven

1.Turn the top oven thermostat control knob to Mk.1 and press the ignition button. As soon as the burner is alight the button can be released.

2.When the oven burner lights up there should be a low gas rate at first to the oven burner, which is the F.S.D. bypass rate.

3.When the F.S.D. phial has heated up it opens the F.S.D. valve and the main gas stream flows to the burner.

4.After 1 minute check that the flame covers the full width of the burner and is stable.

5.Set the oven control to Mk. 2, close the oven door and check that after about 10 minutes the flame size has reduced.

6.Turn off the control knob and check that the oven flames go out.

39

Image 39

Contents User Manual Cooker Contents During use Important safety instructionsInstallation Child safetyCleaning and maintenance Controls and their functions Product descriptionPreparing to use your appliance Before using the applianceRating plate CookwareGrill and oven furniture Electronic timer To set the time of dayTo set the countdown Neon flashes To cancel the countdownCountdown indicator Press the selectorThat the correct time of day is displayed To set the timer to switch on and off automaticallyTo set the timer to switch off only Buttons Cook time indicatorTo stop the sound To the time of dayTo turn off any burner Highest settingHob To light the hob burnersAny spillage should be removed from the lid before opening Things to noteHints and tips Do not overfill pans or they will boil overControl knob to Using the grillGrill To turn off the grillGrill pan and handle Button onSlide the handle Towards the right Food should be turned over during cooking as required Grilling chartTo turn the top oven off Using the top ovenTop oven PreheatingTo fit the top oven shelf Heat zones Using the main ovenTo install a shelf, reverse the above steps Main ovenTo turn the main oven off Approximate Cook time m Oven cooking chartOven cooking chart Cooking time Roasting chartSlow cook Using slow cookGeneral points Food preparation slow cookingCleaning the hob Care and cleaningCleaning materials Cleaning the outside of the applianceCleaning the grill Cleaning the grill and oven furnitureCleaning the doors To remove the inner glassTo replace the inner glass To clean the inner glass door panels Replacing an oven light bulbType of bulb required is a 300C 25 watt small Edison Screw Problem TroubleshootingHob burners will not light Flame colour is orange/yellow 600mm to front of door panel 66Kg 2mm minimum clearance Technical dataHeight Width Depth Weight Gas connection Electrical connection120 Heat input 0kW 9kW 3412 Btu/h 6483 Btu/h070 096 Heat InputNatural Gas versions of this appliance are available Installation instructionsImportant safety requirements Provision for ventilationAppliance For your safetyMoving your appliance Location of applianceBy the earth symbol or coloured green or green and yellow Leveling the applianceIf the fitted plug is removed Connecting to gas supply If a moulded plug is fittedFitting the stability chain Checking the top oven Pressure testingChecking the grill Checking the hobChecking the main oven light Energy save modeEnvironment Checking the main ovenStandard guarantee conditions Guarantee / Customer carePage Page 349143200 12/2006 Subject to change without notice