8b. Setting and starting the programme with "delay start"
Once a programme and required options
have been selected (see point 8a.) to use "delay start" proceed as follows:
Press the "delay start" push button. The digital display will show "h 0". Press the button again to select the number of hours by which you wish to delay the programme start (up to a maximum of 12 hours).
The delay start will not modify the settings made previously .
To set the time setting to zero press the "delay start" push button until "h 0" appears in the digital display.
Press the "programme start" push button. The digital display shows the delay time required before the start of the programme.
The start of the countdown will be confirmed by the flashing "h" in the digital display.
Once the delayed time has elapsed the programme will start automatically.
10. At the end of the washing programme
The dishwasher will automatically stop and an intermittent audible signal informs you that the programme has ended.
Three horizontal lines will appear in the digital display and all the indicator lights of the phases will turn off.
To return to setting mode press any of the push buttons or switch off and then switch on the dishwasher.
The On/Off indicator light remains on until the On/Off push button is depressed.
Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.
Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
9.To cancel a programme in
progress
Press and keep pressed the "programme start" push button for at least 3 seconds to cancel a programme in progress.
Three horizontal lines will appear in the digital display, this means that the dishwasher has returned to setting mode and is now possible to select a new washing programme.
Important!
In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
17 | SEQ33en |