Zanussi DES 959 manual Adjusting the worktop, Fitting under a counter, Levelling

Page 27

Adjusting the worktop

You can move the worktop forward or backward by

25 mm in order to align the machine with other kitchen units.

Simply unscrew the two rear retaining screws, move the top to the required position and then retighten the screws.

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

IN26

570	-
	600
820
600
IN05

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

IN06

IN07

27

INS18UKen

Image 27

Contents Dishwasher Contents During Use Important safety informationInstallation Child SafetyHalf load push button Digital display Delay start push buttonDescription of the appliance Control panelSalt Indicator lightsProgramme phase indicator lights Programme start push buttonAlarm intermittent signal Audible signalsLong programme run signal Intermittent end of programme signalBefore use Setting the water softenerFilling with salt Adjusting the dose Rinse aidEnsure that the lid is closed after every refill To lower the prongs Using your applianceLoading your appliance Lower basketCutlery basket Never lift or lower the basket on one side only Adjusting the height of the upper basketUpper basket To move to the higher position proceed as followsCompact detergents with enzymes Use of detergentItems not suitable for dishwashers Hints and tipsTo save energy For best washing results45C Washing programmes50C 65COpen the door and check Filters Operating sequencePress the On/Off push button Check that There is rinse aid and saltAt the end of the washing programme To cancel a programme ProgressCleaning the large filter Maintenance and cleaningInternal cleaning Cleaning the central filterMoving the machine External cleaningFrost precautions Prolonged periods of non-operationSomething not working Symptom Fault code SolutionService and spare parts Protection against floodingCustomer Care Department This guarantee does not cover Guarantee conditionsStandard guarantee conditions European GuaranteeHints for test centres Technical specificationsWater supply connections Installation instructionsWater outlet hose connection Electrical connection Green and Yellow -Earth Blue-Neutral Brown-LiveProceed as follows Adjusting the worktop Fitting under a counterLevelling