Building-in

Zanussi ZD 699 ALU manual Building-in, To fit the pads, press them onto the feet

Page 29

This dishwasher is designed to be fitted under a kitchen counter or worksurface.

It is essential that the recess dimensions indicated in the diagram are followed.

No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through.

The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm).

A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.

Adjusting the height of the appliance

To adjust the height proceed as follows:

1.Loosen or tighten the two front feet.

2.The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right.

Pads are supplied for the feet to make sliding the appliance in and out of the recess easier.

To fit the pads, press them onto the feet.

If required, the dimensions of these pads can be reduced by breaking them where marked.

596		880
		−
	5	820
7	5	820
5
max
878		600
878
818−
-
+
II60

II52

Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

IN11

IN12

INS69UKen

Image 29

Contents

Dishwasher Contents Installation Important safety informationChild Safety During UseOpen door Control panelSalt Water tapCycle will be carried out Aid is automatically excludedShort instruction accepted signal Audible signalsLong programme run signal Intermittent end of programme signalBefore use Setting the water softenerPress Use salt from level 1 upwardsTo fill with salt, unscrew the cap of the salt container Filling with saltTo fill Rinse aid Adjusting the doseEnsure that the lid is closed after every refill Start from positionLoading your appliance Using your applianceLower basket Open the door and slide out the baskets to load the dishesFor best results use the cutlery grid/s inserts provided Cutlery basketRemovable knife basket When the top basket is in the higher Adjusting the height of the upper basketUpper basket To move to the higher position proceed as followsIf using detergent in tablets proceed as follows If using powder detergents proceed as followsUse of detergent Compact detergents with enzymesTo save energy Hints and tipsFor best washing results Items not suitable for dishwashersWashing programmes Operating sequence Current programme Delay start will not modify the settings made previouslyIt is now possible to select a new washing programme At the end of the washing programmeCleaning the large filter Internal cleaningCleaning the central filter Moving the machine External cleaningFrost precautions Actions listed below Something not workingProtection against flooding Service and spare partsCustomer Care Department Customer Care Department ZanussiStandard guarantee conditions Guarantee conditionsEuropean Guarantee ExclusionsTo contact your local Zanussi Service Centre telephone Zanussi Service ForceMidlands Hints for test centres Technical specificationsWater supply connections Installation instructionsNevertheless we advise a cold water supply Locknut must be correctly fitted to avoid water leaksWater outlet hose connection Electrical connection To fit the pads, press them onto the feet Building-inMounting the infill panel Furniture door plinthFixing to the adjacent units Width 596 mm HeightNoise protection Kitchen plinth adjustmentFitting the vapour protection Electrolux Household Appliances Limited From the Electrolux Group. The world’s No.1 choice

Zanussi ZD 699 ALU manual Building-in, To fit the pads, press them onto the feet

Building-in

Adjusting the height of the appliance

To fit the pads, press them onto the feet.

600

818−