Zanussi ZT 415 manual Operating Instructions

Page 12

OPERATING INSTRUCTIONS

1 Check that the filters are clean

7 Start the programme

(see cleaning instructions)

Open the water supply.

 

2 Switch on the appliance at the mains supply.

3 Check that there is salt and rinse aid

4 Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

Ensure that the spray arms can rotate freely.

5 Measure out detergent

Pour the required amount of detergent into the dispenser according to the indications in the Washing Programmes chart and close the lid.

6 Set the programme

The selection of a programme occurs with the door partially opened.

Depress ON/OFF button (1); the ON/OFF indicator light (3) comes on.

Depress the programme button which corresponds to the washing programme you wish to select; the corre- sponding indicator light will flash.

Close the dishwasher door. An audible signal of about 1 second advises you that the programme has started. The indicator light which corresponds to the programme under way is now permanently on.

Caution

In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.

If you need to stop the dishwasher at any moment during the wash programme, switch the appliance off at the plug; open the door and press the ON/OFF button.

Care must be taken if opening the door, as steam will escape.

8 At the end of the washing programme

The dishwasher will automatically stop and an inter- mittent audible signal of about 5 sec. informs you that the programme has finished.

Wait until the end of the signal before opening the door.

Open the door. The End of Cycle indicator light flashes. Depress the ON/OFF button to switch the dishwasher off.

You are advised to turn off the water tap and switch off the appliance at the plug socket.

Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.

Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

8 Cancel the wash programme

To change a wash programme in progress depress the button corresponding to the programme you wish to cancel for about 1 sec., until the relevant control light goes out. The dishwasher is now reset and you can select a new programme.

PSO04GB

12

Image 12 Contents
Dishwasher ZT Contents Technical SpecificationsInstallation Child SafetyDuring Use ConservationInstallation PositioningLevelling Water Outlet ConnectionElectrical connections USE Water Softener Filling with SaltSalt Must be used regularly from level 2 upward Adjusting the Dose Rinse Aid Filling with Rinse Aid Use of DetergentLoading your Machine Use of the Lower BasketUse of the Upper Basket Adjusting the Height of the Upper Basket Helpful HintsFor Best Washing Results Items not Suitable for DishwashersWashing Programmes OFFOperating Instructions Maintenance and Cleaning Cleaning the Central FiltersCleaning the Large Filter Internal and External CleaningIf the indicator light of the Quick programme is flashing ServicingService detail adhesive label Dishes are not quite dryDoor is difficult to close Building-in features BUILDING-INFitting under a counter kitchen worktop or sink Fitting the panel onto the doorKitchen plinth adjustment 136 131 125 118 110 100 135 102 137 132Depth 138 134 120 110 139 130 124 115 105 129 100 135 125 Zanussi guarantee conditions Peace of Mind for Twenty Four MonthsExclusions Page 152995 81/0 1096