Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2. Press the ON-OFF push button
The display will show the last selected programme (if programme options have been selected the corresponding lights will illuminate).
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely.
6.Measure out detergent
Add the required amount of detergent into the dispenser.
Important!
If the half load option is selected remember to reduce the quantity of detergent.
Close the detergent dispenser lid.
7a. Setting and starting the programme without "DELAY START"
The selection of the programme occurs with the door partially opened.
Press the "PROGRAMMES SELECTION" push button until the required programme number appears in the digital display (see "Washing programmes" chart).
To see the duration of the programme (in
minutes), only with open door,press the "CANCEL" push button
The following options may also be selected:
●HALF LOAD : by pressing the corresponding push button
● ECO DRY | or NO DRY | by pressing the |
corresponding push button. |
| |
Close the door, the programme will start automatically and an audible signal advises you of this.
All the indicator lights will turn off.
The display will show the running time of the programme.
7b. Setting and starting the programme with "DELAY START"
Once a programme and required options have
been selected (see point 7a.) to use DELAY proceed as follows:
Press the | DELAY | push button. |
|
The digital display will show "h 0". |
| ||
If other options have been selected the |
| ||
corresponding indicator lights will turn off, but |
| ||
this will not modify the settings made previously. |
| ||
Press the button again to select the number of |
| ||
hours by which you wish to delay the programme |
| ||
start (up to a maximum of 12 hours). |
| ||
To set the time setting to zero press the | DELAY | ||
push button until "h 0" appears in the digital |
| ||
display. |
|
|
|
Close the door, an audible signal will confirm |
| ||
the starting of the countdown. |
| ||
The digital display shows the delay time, which |
| ||
will decrease in steps of 1 hour. |
| ||
The progression of the countdown will be |
| ||
confirme | d by a flashing dot in the digital display. |
| |
Once the delayed time has elapsed the programme will start automatically and in the digital display will appear the duration of the programme.
The opening of the door will not stop the countdown.
15