Zanussi ZC 605 M manual GAS Connection, Connection Using a Rigid Pipe or a Flexible Metal Pipe

Page 15

GAS CONNECTION

Gas connection must be carried out according to the rules in force.

The manufacturing company release the unit, once tested, adjusted for the kind of gas stated on the rating plate located on the back of the range, next to connection pipe. Be sure that you are going to connect the unit to the same kind of gas written on the plate.

CONNECTION USING A RIGID PIPE OR A

FLEXIBLE METAL PIPE

To ensure higher safety, it is recommended to carry out the connection to the gas system using rigid pipes (ex. copper) or using flexible stainless steel pipes, to avoid any stress to the unit.

Gas feeding pipe fitting is Gc 1/2.

For this type of installation, connection to the gas supply should be carried out using only and exclusively flexible metallic tubes in conformity with rules in force.

CONNECTION USING FLEXIBLE,

NON METAL PIPES

When the connection can be easily inspected in its full extent, there is the chance to use a flexible pipe according to the rules in force.

The flexible pipe must be tightly fixed using clamps according to the rules in force.

The flexible pipe should be made ready for use in such a way that:

-nowhere it can reach overtemperature, other than room temperature, higher than 30°C; if the flexible

pipe, to reach the cock, must run behind the range, it must be installed as shown in Fig. 13;

- it is no longer than 1500 mm;

-it shows no throttles;

- it is not subject to traction or torsion;

-it doesn't get in touch with cutting edges or corners;

-it can be easily inspected in order to check its

condition.

The control of preservation of the flexible pipe consists in checking that:

-it doesn't show cracks, cuts, marks of burnings both on the end parts and on its full extent;

-the material is not hardened, but shows its normal elasticity;

- the fastening clamps are not rusted; - expiry term is not due.

If one or more abnormalities are seen, do not repair the pipe, but replace it.

IMPORTANT

FO 0163

Once installation is complete, check the perfect seal of every pipe fitting, using a soapy solution, never a flame.

YES

FLEXIBLE

RUBBER

GAS PIPELINE

ELECTRIC

WIRE

NO

FLEXIBLE

RUBBER

GAS PIPELINE

ELECTRIC

WIRE

Fig. 13

69

Image 15
Contents ZC 605 M Appliance Class 1 Class 2 Sub-Class GuaranteePage Dimensions of the Unit ContentsUSE InstallationInstructions for the User PotteryElectric Oven 5 Functions Models equipped with an oven grill with stopper Manual operation Switch aSwitch B ProgrammingAdvice for USE of the HOB Burners Advice for the USE of Your OvenCooking in the multi-function oven Cooking times For the preparation of cakesFor the preparation of meat For the preparation of fishTable for Traditional and Convection Cooking GrillingFlans Macaroni Vegetable Small quiches Lasagne Cleaning the oven door MaintenanceCleaning the oven Oven lamp replacement FigCare of Catalytic Side Panels Lid cleaningPractical advice How to diminish splashes? Some adviceLevelling Instructions for the InstallerCombustion Products Discharge PositioningGAS Connection Connection Using a Rigid Pipe or a Flexible Metal PipeConnection Using Flexible NON Metal Pipes Flexible Rubber GAS Pipeline Electric WireAdaptation to Different Kinds of GAS HOB Burners Nozzles ReplacementHOB Burners Adjustment of Minimum Level Normal power Reduced powerElectrical Connection Phase Wire Ground yellow greenMaintenance Technical Assistance What to do if the Appliance Doesnt WorkOriginal Spare Parts