Before connecting the STEREO VITALIZER switch the power off at all connected units.
The STEREO VITALIZER is available in two version up to autumn 1995:
Version 1: unbalanced jack version
Version 2: professional version with unbalanced (switching mono- 1/4“jacks wired tip hot) and electronically balanced
From autumn 1995 only version 2 will be available.
Insert your STEREO VITALIZER into the
Never connet the STEREO VITALIZER between console and amplifier! Each fader movement will result in a tonal change of the STEREO
A switch on the rear panel sets the input operating level for both chan- nels. Two positions are available: The
The unit may be run hotter if desired by switching the level setting from the HIGH to the LOW working level with the proviso that the PEAK LEDs on the front panel are not regularly flashing. This will achieve processing at a lower input sensitivity and will result in a more intensely processed sound.
Conversely, in order to achieve milder processing, the switch may be set from LOW to HIGH.
Should the need arise to use the XLR connectors in an unbalanced system, pin 3 of both the input and output connectors should be grounded. Note that unbalancing the output in this way will cause a level increase of 6dB. Follow the diagram below:
The Pin assignment of the
Connections
Version 1 | Model 9319 | Version 2 | Model 9320 |
Inputs
balanced unbalanced
Pin
wiring:
1 = Ground
2 = hot (+)
3 = cold
Outputs
balanced unbalanced
S T E R E O | 5 |