POSITIONING
Height adjustment
The height of the appliance is adjustable from 820 to 870 mm to fine up with existing kitchen units.
Before installing the appliance between unite, adjust the height of the feet and rear wheels. The wheels are factory set for a height of 820 mm. To align the appliance to a height of 870 mm, raise it by adjusting the feet with a spanner, then remove the wheels and refit them in the lowest position.
Fitting the side panels
•Fit the brackets onto the panels in the positions shown in the diagram. The dimension of 260* mm is allowed for fitting a 100 mm plinth below the panel. For different plinth sizes, increase the dimension of 260* mm accordingly.
•Rest the panels against the appliance.
•Fit the rear brackets, taking into account the thickness of the panels (maximum width of unit 900 mm).
•For a correct alignment make sure that the distance between the appliance and the cabinet is of 45 mm.
•Secure the panels at the front.
•Check the alignment of the doors, loosening the fixing nuts and screws and by means of the slots.
•Tighten the clamp screw on the bottom hinges of the doors.
| 820 |
| 870 |
820 |
|
870 |
|
REAR | FRONT |
EDGE | EDGE |
RIGHT HAND
SIDE PANEL
15 |
|
| 17,5 |
|
|
| |
| INSIDE | 1015 | |
820 |
| ||
FACE |
| ||
15 |
|
| 64 |
280 |
|
| |
|
|
| |
|
|
| 539 |
| 541 | 30 | 260* |
|
|
|
28