5Remove the correct part from the hinge cover
(E). Make sure to remove the part DX, in the case of right hinge, SX in oppo- site case.
| C |
| D |
E | E |
|
B
6Attach the covers (C, D) to the lugs and the hinge holes.
Install the vent grille (B). Attach the hinge covers (E) to the hinge.
HaHb
Hc Hd
8 mm
Hb
Ha
11Open the appliance door and the kitchen fur- niture door at an angle of 90°.
Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture door and mark the holes.
8 mm
K Ha
12Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).
7 Fix the appliance to |
the side of the kitchen |
unit, fit the bracket (E) and |
8Disconnect the parts (Ha), (Hb), (Hc) and (Hd).
Hb
Hb 
Hd 
(F), adjust the distance, |
and fix using the screws |
(as in figure). |
Fit the cover (D). |
13 Place the small square |
on the guide again and fix |
it with the screws sup- |
plied. |
Align the kitchen furniture |
14Press the part (Hd) on the part (Hb).
~50 mm 90o 
Ha 21 mm
90o 
~50 mm 
21 mm
Hc
9 Install the part (Ha) on | 10 Push the part (Hc) on |
the inner side of the kitch- | the part (Ha). |
en furniture. |
|
www.zanussi.com
door and the appliance |
door by adjusting the part |
Hb. |
Do a final check to make sure that:
•All screws are tightened.
•The magnetic sealing strip is attached tightly to the cabinet.
Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases.
13