Sherwood RX-765 operating instructions Tuning to preset stations, Memory Backup Function

Select the desired preset number (1~30)				Repeat the above steps 1 to 3 to memorize
3 and press the MEMORY button.				4 other stations.
	T/P
TUNE	TUNE		MEMO
	+
MEMORY
or	TREBLE	+	MUTE
			BASS
			+
		VOL.
	TUNE	MEMO	TUNE
			+
	FM MODE	VOL.	P.SCAN
• When using the NUMERIC buttons on the remote				MEMORY BACKUP FUNCTION
control.				The following items, set before the receiver is turned
Examples) For “3” :	3			off, are memorized.
For “15” :	within 2 seconds			• INPUT SELECTOR settings
	1		5	• Preset stations,etc.
For “30” :
	0			Note
• The station has now been stored in the memory.
				• If the electricity fails or the AC input cord is
• When using the NUMERIC buttons, the station is stored
				disconnected for more than 2 weeks, they are all
automatically without pressing the MEMO button.				cleared. So you should memorize them again.

•A stored frequency is erased from the memory by storing another frequency in its place.

•If “MEMO” goes off, start again from the above step 2.

Tuning to preset stations					Select the desired preset number.
					2
										A
										DECK SEL.	TAPE
	After selecting the tuner as an input									B
										TREBLE +	BASS
1	source, select the preset mode.										+
							or			T/P	MUTE
					TUNING/PRESET				TUNE	TUNE	VOL.
		A								+TUNE
		DECK SEL.	TAPE								MEMO TUNE
		B									+
										FM MODE	P.SCAN
			+								VOL.
		TREBLE		BASS
T/P MODE				+
	T/P	T/P		MUTE
					• When using the NUMERIC buttons on the remote
	or		VOL.
		TUNE	MEMO	TUNE	control.
				+
		FM MODE	VOL.	P.SCAN	Examples) For “3”			:	3
					For “15”			:	within 2 seconds
									1		5
• Then “PRESET” lights up.					For “30”			:	0
					• When selecting the desired preset number with the
					NUMERIC buttons, the desired preset station will be
					tuned to automatically without selecting the preset mode.
Listening to FM stereo broadcasts					Scanning preset stations in sequence
• While listening to FM broadcasts,				T/P	TREBLE +		BASS
				VOL.			+
	FM MODE			TUNE MEMO	T/P		MUTE
				FM MODE		VOL.
				VOL.
					TUNE	MEMO	TUNE
• Each time this button is pressed,							+			P.SCAN
					FM MODE		P.SCAN
the FM mode changes as follows:						VOL.
Stereo mode : “ST” lights up.
Mono mode : “ST” goes off.
• When FM stereo broadcasts are poor because of weak					• The receiver will start scanning the stations in the preset
broadcast signals, select the FM mono mode to reduce					sequence.
the noise, then FM broadcasts are reproduced in					• At the desired station, press this button again to stop
monaural sound.					scanning.

1 4