Sherwood RX-765 AC Input Cord, Switched AC Outlets, Connecting System Control

■ AC INPUT CORD

Plug this cord into a wall

AC outlet.

AC INPUT

120V~60Hz

2.5A

	AVIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.					MODEL NO. RX-765
	WARNING : SHOCK HAZARD-DO NOT OPEN.			LISTED		STEREO RECEIVER
				E208974 7H86
	THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.			AUDIO/VIDEO	SPEAKERS	MADE IN CHINA
				EQUIPMENT		DESIGNED IN USA
AM	OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:					SER. NO
LOOP
	(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
	(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
	INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.				A	AC OUTLET
	CD TV/AUX	TAPE	VIDEO	DIGI-
FM				LINK
75
					B

ANTENNA	SPEAKER IMPEDANCE
	A, B - 8 MIN / SPEAKERS	SWITCHED
	A+B -16 MIN / SPEAKERS
		120V~60Hz

100W 1A MAX

■SWITCHED AC OUTLETS

•These outlets are switched on(power-on mode) and off(standby mode) according to power control as follows(Maximum total capacity is 100W,1A ):

Standby mode — switched AC outlet off Power-on mode — switched AC outlet on

■CONNECTING SYSTEM CONTROL

	Sherwood component
DIGI-	with DIGI LINK II or III
LINK
	CD player	System
		control
	Tape deck, etc.	cord

•Connect this jack to the DIGI LINK jack of the external Sherwood component that uses the DIGI LINK II or III remote control system.

■CONNECTING SPEAKERS

Speaker A

Right Left

SPEAKERS

Right Left

Speaker B

•Usually SPEAKER A terminals are used for only a pair of speakers. When you have another pair of speakers, SPEAKER B terminals can be used.

•Never short-circuit the + and - speaker cords.

•Be sure to connect speakers firmly and correctly according to the channel (left and right) and the polarity (+ and -).

■Note :

•For safe amplifier operation, use the speakers with impedance of over 8Ω when you use only SPEAKER A or B terminals and use the speakers with impedance of over 16Ω when you use both SPEAKER A and B terminals.

7