Tricity Bendix DH 086 manual Internal cleaning, Cleaning the large filter, External cleaning

Page 14

Maintenance and cleaning

Internal cleaning

Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

We recommend the use of

Finish Dishwasher Cleaner

every 3 months or run a 65°C wash without dishes using

detergent. Regular use of Finish Dishwasher Cleaner cleans

inaccessible parts, eliminates unpleasant food odours and

helps prevent the build-up of limescale.

 

Cleaning the central filters

(After each

wash)

Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter

(C) can be removed by pressing the two tongues (D).

Once cleaned, refit the filters by pressing them down until they click into place.

Cleaning the large filter

(every week)

Clean the large filter (A) on both sides under running water, using a brush.

To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order.

External cleaning

Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....).

Prolonged periods of non-operation

If you are not using the machine for any period of time you are advised to:

1.Unplug the appliance and then turn off the water.

2.Fill the rinse aid dispenser.

3.Leave the door ajar to prevent the formation of any unpleasant smells.

4.Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the

temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water

inlet pipe and empty it.

Moving the machine

If you have to move the machine (moving house etc....

):

1.Unplug it.

2.Turn the water tap off.

3.Remove the water inlet and discharge hoses.

4.Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.

 

C

 

D

 

B

MA13

MA08

 

E

A

 

F

 

MA01

 

The dishwasher must not be used without filters.

Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine.

14

Image 14
Contents Dishwasher Contents Child Safety Important safety informationInstallation ConservationPrewash / Rinse and Hold Wash Cold rinse Hot rinse Drying Wash programme phase indicatorControl panel Before use Setting the water softenerTo adjust the water softener Level Levels 3To fill with salt, unscrew the cap of the salt container Filling with saltTo fill Filling with rinse aid Adjusting the doseRinse aid Ensure that the lid is closed after every refillLower basket Using your applianceLoading your appliance Open the door and slide out the baskets to load the dishesTo move to the higher position proceed as follows Adjusting the height of the upper basketUpper basket Use of detergent Compact detergents with enzymesFor best washing and drying results Hints and tipsTo save energy Items not suitable for dishwashersWashing programmes Programme Degree of soilOperating sequence External cleaning Internal cleaningCleaning the large filter Frost precautionsSomething not working Service and spare partsSymptom Always insist on genuine spare partsTechnical specifications Hints for test centresRemove all packaging before positioning the machine Water supply connectionsWater outlet hose connection This dishwasher must be plumbed into a cold water supplyElectrical connection Levelling Adjusting the worktopFitting under a counter Kitchen worktop or sinkCustomer care telephone number 08705 950 152995 62/3