Installation instructions
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Water supply connections
This dishwasher must be plumbed into a cold water supply.
The water pressure must be within the limits given in the technical specifications.
Your local Water Authority will advise you on the average mains pressure in your area.
The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation.
The locknut must be correctly fitted to avoid water leaks.
Avoid bends or kinks in the hose which could prevent or slow down the water supply.
If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter.
Do not use, for the connection, old hoses which have been used in another appliance.
Water outlet hose connection
The end of the drain hose can be connected in the following ways:
1.To the sink outlet siphon, securing it if necessary with a clip.
2.Hooked over the edge of the sink using the special curved plastic guide provided.
3.To a stand pipe provided with
The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher.
The drain hose can face either to the right or left of the dishwasher
Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.
The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine.
|
| 1 | 2 | 3 |
Ø | 21 |
|
| 4 cm |
18 |
| min | ||
|
| |||
| Ø |
| ||
|
|
| ||
|
|
|
| |
|
|
| max 100 cm | min 30 cm max 100 cm |
CS09 |
|
|
|
|
Ø 18 | Ø 21 |
|
|
|
| cm |
|
+ 2 m max | max 100 | min 30 cm max 100 cm | |
|
| ||
CS10 |
|
|
|
17