Adjusting the tone(bass and treble)
Enter the tone mode.
8
TONE
or
TONE SEL.
Each time this button is pressed, the corresponding tone mode is selected and shown for 5 seconds as follows:
BAS(s) TRE(ble)
Note:
When the tone direct function is activated, the tone mode cannot be entered and
9 | At the desired tone mode, adjust the tone |
as desired. |
or TREBLE/BASS
If the tone display disappears, start from the step 8 again.
Notes:
Extreme settings at high volume may damage your speakers.
In general, the bass and treble levels are adjusted to 0.
ENGLISH
To listen to a program source without the tone effect.
10
TONE DIRECT
To cancel the tone direct function, press this button again to display
Adjusting the sound volume balance
Enter the balance mode.
11
BALANCE
“BAL” is displayed for 5 seconds.
Adjust the sound volume balance between
12 the left and right speakers.
or
BALANCE
If the balance display disappears, start from the step 11 again.
When the BALANCE / buttons on the remote control are pressed, it enters the balance mode automatically without pressing the BALANCE button on the front panel.
Note:
In general, the balance level is set to the center position(red dot).
11