Frigidaire FRS6B6EEW0, FSC23R5DSB7 warranty PURESOURCE2TM * ICE and Water Front Filter Some Models

Page 16

AUTOMATIC ICE AND WATER DISPENSER

PURESOURCE2TM * ICE AND WATER FRONT FILTER (SOME MODELS)

NOTE

If you purchased a refrigerator with a PureSource2TM * Ice and Water front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right front corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.

The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

Order new filter cartridges through the dealer where you bought the refrigerator, contact the Consumer Assistance Center at 1- 800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the FC-

100PureSource™* replacement cartridge.

The PureSource2TM* Ice and Water Filter System NGFC 2000 with the PureSource2TM* cartridge FC 100 is tested and certified by NSF International, the nationally recognized and respected, not for profit, certification

organization for public health safety. The PureSource2TM* Filter system is tested and certified to ANSI/NSF Standards 42 and 53. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every

6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the

filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Set ice maker wire signal arm to the OFF (up) position (side mounted) or the ice maker’s On/Off power switch turned Off-set to the “O” position (rear mounted) .

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

NOTE

A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing. Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.

3.Pull the old filter cartridge straight out of the housing.

4.Discard the old filter.

5.Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out.

6.When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing.

7.Set ice maker wire signal arm to the ON (down) position (side mounted) or the ice maker’s On/Off power switch is turned On- set to the “I” position. (rear mounted).

8.Fill a glass with water. As you are doing this, check for leaks at the filter housing. There will be noticable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. This is normal.

9.After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank.

IMPORTANT

Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10- 15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

*White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Use & Care Manual Please Read and Savethese Instructions Welcome & CongratulationsRegistration Card Included Withyour Important Safety Instructions Foryour SafetyChild Safety Proper Disposal Ofyour Refrigerator or FreezerInstallation Before Installing The Water Supply Line,You Will Need Installation Connecting ICE Maker to Water SupplyTo Connect Water Supply Line To Ice Maker Inlet Valve Door Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorFeatures AT a Glance Temperature ControlsSetting Coolingtemperatures Allowing Coolingtime Before USEWhat to do if the Temperature Displays Flash Makingtemperature AdjustmentsChoosing Fahrenheit or Centigrade SYSTEM-MONITORING Alarms Respondingto Alarms Audibletones Indicator LightsAIR Filter Indicator & Status Lights Turningthe Cooling System on and OFFLooking Inside Looking Inside Special Storage Areas Tall Bottle Retainer Some ModelsCrispers Some Humidity Control Some ModelsAutomatic ICE and Water Dispenser Automatic ICE & Water Dispenser Operating InstructionsICE and Water Dispenser Features Howthe Water Dispenser WorksHowthe ICE Dispenser Works -SIDE Mounted Howthe ICE Dispenser Works -REAR MountedCleaningthe ICE Dispenser Remove and empty the ice storage bin ifPuresource TM * ICE and Water Filter Some Models System StartupResetting The Filter Status Light some models PURESOURCE2TM * ICE and Water Front Filter Some ModelsPuresource MB ICE and Water Front Filter Some Models Food Storage Ideas Food Storage & Energy Saving IdeasEnergy Saving Ideas Normal Operating Sounds & Sights Understandingthe Soundsyou MAY HearCondenser Motorized DamperCare & Cleaning Replacing Light Bulbs Warranty Information ConsumerBefore YOU Call OPENING/CLOSING of DOORS/DRAWERSDOORS/DRAWERS WarmEnough ice Ice maker will not stopMaking ice Ice maker is not separatingRefrigerator

FRS6B5EEW7, FRS6B6EEB0, FRS6B5EEW5, FSC23R5DSB4, FSC23R5DSB9 specifications

Frigidaire is renowned for producing high-quality appliances that enhance the convenience and efficiency of modern kitchen environments. The models FSC23R5DSB7, FSC23R5DB7, FRS6L7EES9, FRS6B7EESB8, and FRS6L9EFSS0 are prime examples of their commitment to innovation and functionality in refrigerator design.

The Frigidaire FSC23R5DSB7 and FSC23R5DB7 are side-by-side refrigerators that feature a sleek stainless steel finish, which not only adds elegance to your kitchen but is also easy to clean. With a total capacity exceeding 21 cubic feet, these models offer ample storage space with adjustable shelves and a dedicated crisper drawer for fruits and vegetables, ensuring items remain fresh longer. The integrated ice and water dispenser provides chilled water and ice on demand, enhancing convenience for families or anyone who enjoys entertaining.

The FRS6L7EES9 and FRS6B7EESB8 are also side-by-side refrigerators, boasting similar designs and features. Both models include the SpaceWise organization system, allowing users to customize the interior for better storage efficiency. The adjustable shelving and door bins are designed to accommodate larger items, ensuring flexibility in food storage. In addition, these models are equipped with advanced temperature management systems that maintain optimal cooling conditions, contributing to food preservation and energy efficiency.

For those looking for enhanced performance, the FRS6L9EFSS0 model is a standout with its TwinTech cooling system. This technology provides two cooling systems: one for the refrigerator and one for the freezer. This separation helps maintain ideal humidity levels and temperature consistency in both compartments, ensuring that food stays fresh while minimizing freezer burn.

All these models are designed with Energy Star compliance, reflecting their efficiency and commitment to reducing energy usage without compromising performance. They also come with a variety of smart features that allow for monitoring and adjusting settings easily, which can enhance the user experience further.

In summary, the Frigidaire FSC23R5DSB7, FSC23R5DB7, FRS6L7EES9, FRS6B7EESB8, and FRS6L9EFSS0 models embody Frigidaire's dedication to quality, style, and innovative technology. Their spacious interiors, advanced cooling systems, and energy-efficient designs make them excellent choices for any modern kitchen.
Top Page Image Contents