Frigidaire FRS6L7EES9 warranty Puresource TM * ICE and Water Filter Some Models, System Startup

Page 15

AUTOMATIC ICE AND WATER DISPENSER

PURESOURCE TM * ICE AND WATER FILTER (SOME MODELS)

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

NOTE

If you purchased a refrigerator with a PureSource TM * Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.

Order new filter cartridges through the dealer where you bought the refrigerator, contact the Consumer Assistance Center at 1- 800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG-100 PureSource™* replacement cartridge.

The PureSource™ * NGRG-2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International, the nationally recognized and respected, not for profit, certification organization for public health safety.

The PureSource™* system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator.

The dispenser system will also operate without filtration (with filter cartridge removed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Open freezer door and leave open until filter change is complete.

2.Set ice maker wire signal arm to the OFF (up) position (side mounted) or the ice maker’s On/Off power switch turned Off-set to the “O” position (rear mounted) .

3.Hold filter cup firmly, and unscrew towards left (Some water could leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.

4.Rinse out cup under running water.

5.The large o-ring that seals the filter system sets in the o-ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If the o-ring becomes damaged, you will need to order one from the Consumer Assistance Center.

6.Discard old filter cartridge.

7.Remove new filter cartridge from packaging. Place in cup. The end with the small o-ring should be up, out of the cup.

8.Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do NotTighten Past Stop.

9.Set ice maker wire signal arm to the ON (down) position (side mounted) or the ice maker’s On/Off power switch is turned On-set to the “I” position. (rear mounted).

10.Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.

11.To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.

IMPORTANT

ResettingThe Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.

*White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter. 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Use & Care Manual Welcome & Congratulations Please Read and Savethese InstructionsRegistration Card Included Withyour Proper Disposal Ofyour Refrigerator or Freezer Important Safety InstructionsForyour Safety Child SafetyInstallation Installation Connecting ICE Maker to Water Supply Before Installing The Water Supply Line,You Will NeedTo Connect Water Supply Line To Ice Maker Inlet Valve To Remove Freezer Door Door Removal InstructionsDoor Removal Instructions To Remove Refrigerator DoorAllowing Coolingtime Before USE Features AT a GlanceTemperature Controls Setting CoolingtemperaturesMakingtemperature Adjustments What to do if the Temperature Displays FlashChoosing Fahrenheit or Centigrade Turningthe Cooling System on and OFF SYSTEM-MONITORING AlarmsRespondingto Alarms Audibletones Indicator Lights AIR Filter Indicator & Status LightsLooking Inside Humidity Control Some Models Looking Inside Special Storage AreasTall Bottle Retainer Some Models Crispers SomeAutomatic ICE & Water Dispenser Operating Instructions Automatic ICE and Water DispenserHowthe ICE Dispenser Works -REAR Mounted ICE and Water Dispenser FeaturesHowthe Water Dispenser Works Howthe ICE Dispenser Works -SIDE MountedRemove and empty the ice storage bin if Cleaningthe ICE DispenserSystem Startup Puresource TM * ICE and Water Filter Some ModelsPURESOURCE2TM * ICE and Water Front Filter Some Models Resetting The Filter Status Light some modelsPuresource MB ICE and Water Front Filter Some Models Food Storage & Energy Saving Ideas Food Storage IdeasEnergy Saving Ideas Motorized Damper Normal Operating Sounds & SightsUnderstandingthe Soundsyou MAY Hear CondenserCare & Cleaning Replacing Light Bulbs Consumer Warranty InformationOPENING/CLOSING of DOORS/DRAWERS Before YOU CallWarm DOORS/DRAWERSIce maker is not separating Enough iceIce maker will not stop Making iceRefrigerator

FRS6B5EEW7, FRS6B6EEB0, FRS6B5EEW5, FSC23R5DSB4, FSC23R5DSB9 specifications

Frigidaire is renowned for producing high-quality appliances that enhance the convenience and efficiency of modern kitchen environments. The models FSC23R5DSB7, FSC23R5DB7, FRS6L7EES9, FRS6B7EESB8, and FRS6L9EFSS0 are prime examples of their commitment to innovation and functionality in refrigerator design.

The Frigidaire FSC23R5DSB7 and FSC23R5DB7 are side-by-side refrigerators that feature a sleek stainless steel finish, which not only adds elegance to your kitchen but is also easy to clean. With a total capacity exceeding 21 cubic feet, these models offer ample storage space with adjustable shelves and a dedicated crisper drawer for fruits and vegetables, ensuring items remain fresh longer. The integrated ice and water dispenser provides chilled water and ice on demand, enhancing convenience for families or anyone who enjoys entertaining.

The FRS6L7EES9 and FRS6B7EESB8 are also side-by-side refrigerators, boasting similar designs and features. Both models include the SpaceWise organization system, allowing users to customize the interior for better storage efficiency. The adjustable shelving and door bins are designed to accommodate larger items, ensuring flexibility in food storage. In addition, these models are equipped with advanced temperature management systems that maintain optimal cooling conditions, contributing to food preservation and energy efficiency.

For those looking for enhanced performance, the FRS6L9EFSS0 model is a standout with its TwinTech cooling system. This technology provides two cooling systems: one for the refrigerator and one for the freezer. This separation helps maintain ideal humidity levels and temperature consistency in both compartments, ensuring that food stays fresh while minimizing freezer burn.

All these models are designed with Energy Star compliance, reflecting their efficiency and commitment to reducing energy usage without compromising performance. They also come with a variety of smart features that allow for monitoring and adjusting settings easily, which can enhance the user experience further.

In summary, the Frigidaire FSC23R5DSB7, FSC23R5DB7, FRS6L7EES9, FRS6B7EESB8, and FRS6L9EFSS0 models embody Frigidaire's dedication to quality, style, and innovative technology. Their spacious interiors, advanced cooling systems, and energy-efficient designs make them excellent choices for any modern kitchen.
Top Page Image Contents