Frigidaire FSC23F7DSB0 PureSource2TM * Ice and Water Front Filter some models, System Startup

Page 17

Automatic Ice and Water Dispenser

PureSource2TM * Ice and Water Front Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource2TM * Ice and Water front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is

located in the upper right front corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.

The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1. Turn the ice maker’s power switch to the Off (“O”) position (See illustration on page 14).

Order new filter cartridges through the dealer where you bought the refrigerator, contact the Customer Care Center at 1-800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the FC-100 PureSource™* replacement cartridge.

The PureSource2TM* Ice and

Water Filter System NGFC 2000 with the PureSource2TM* cartridge FC 100 is tested and certified by NSF International,

the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource2TM* Filter system is tested and certified to ANSI/ NSF Standards 42 and 53. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

NOTE: A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing. Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.

3.Pull the old filter cartridge straight out of the housing.

4.Discard the old filter.

5.Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out.

6.When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing.

7.Turn the ice maker’s power switch to the On (“I”) position.

8.Fill a glass with water. As you are doing this, check for leaks at the filter housing. There will be noticeable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. This is normal.

9.After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank.

IMPORTANT: Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 241540300 Please Read and Save These Instructions Welcome & CongratulationsFor Your Safety Important Safety InstructionsChild Safety Proper Disposal of Your Refrigerator or FreezerInstallation To Connect Water Supply Line To Ice Maker Inlet Valve Before Installing The Water Supply Line, You Will NeedDoor Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorFeatures At a Glance Temperature Adjustment Temperature ControlsIf Temperature Displays Flash Cool Down PeriodTurning the Cooling System on and OFF Other Control FeaturesDoor Ajar Indicator To adjust cantilever shelves Cantilever Shelf AdjustmentLooking Inside ICE Cream Shelf Some ModelsDoor Storage Adjustable Door BinsTall Bottle Retainer Some Models Special Item Rack Some ModelsMeat Keeper Humidity Control Some ModelsAutomatic ICE & Water Dispenser Operating Instructions Automatic Ice and Water DispenserHow the Water Dispenser Works ICE and Water Dispenser FeaturesHow the Ice Dispenser Works ICE Dispenser TipsRemove and empty the ice storage bin if Cleaning the ICE DispenserTo change filter Changing the FilterSystem Startup PureSource2TM * Ice and Water Front Filter some modelsChanging the Filter To change filterEnergy Saving Ideas Food Storage & Energy Saving IdeasFood Storage Ideas Normal Operating Sounds & Sights Care & Cleaning Chart Care & CleaningReplacing Light Bulbs Vacation and Moving TipsRefrigerator Warranty Warranty InformationBefore You Call Problem Cause CorrectionProblem Cause Correction ICE Dispenser Problem Cause Correction

FSC23F7DB0, FSC23BBDSB0, FSC23F7DSB1, FSC23F7DSB0, FSC23BBDSB1 specifications

Frigidaire has long been synonymous with innovation and quality in the appliance industry, and their line of refrigerators including the FSC23BBDSB1, FSC23F7DSB0, FSC23F7DSB1, FSC23BBDSB0, and FSC23F7DB0 exemplifies these qualities.

These models showcase a modern, sleek design, perfect for any contemporary kitchen. One of the primary features is spacious storage capacity, allowing homeowners to organize their groceries conveniently. With adjustable shelving and door bins, users can customize the interior layout based on their needs.

Energy efficiency is another hallmark of these Frigidaire models. Each unit is designed with energy-saving technologies that not only help reduce electricity bills but also promote sustainable living. The ENERGY STAR rating on these refrigerators highlights their commitment to energy efficiency, making them an eco-friendly choice for the environmentally conscious consumer.

In terms of temperature management, these refrigerators feature advanced cooling systems that ensure consistent temperatures throughout the unit. This is crucial in maintaining the freshness of food and beverages. The models come equipped with an automatic defrost feature, minimizing the need for manual intervention and ensuring optimal performance.

The stainless steel finish gives the refrigerators a premium look, while also being easy to clean and resistant to fingerprints. This aesthetic appeal is matched by practicality, as the units often include LED lighting that illuminates the interior, making it easier to locate items even in low light.

Technology is also a standout aspect of the FSC23 series. Many of these models feature smart capabilities, allowing users to control and monitor their refrigerators remotely. Whether adjusting temperatures, receiving alerts about issues, or managing grocery inventory, modern connectivity enhances user convenience.

Additionally, these refrigerators often come with specialized compartments, such as humidity-controlled crispers for fruits and vegetables, as well as dedicated meat drawers, ensuring food stays fresh for longer periods.

Overall, the Frigidaire FSC23 series represents a blend of style, efficiency, and advanced technology, making them an excellent choice for anyone in the market for a reliable and stylish refrigerator. With a commitment to quality and innovation, Frigidaire continues to set benchmarks in the home appliance industry.
Top Page Image Contents