Frigidaire FRS23F4CQ2 Puresource TM * ICE and Water Filter Some Models, System Startup, Stop

Page 12

AUTOMATIC ICE AND WATER DISPENSER

PURESOURCE TM * ICE AND WATER FILTER (SOME MODELS)

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

NOTE

If you purchased a refrigerator with a PureSource TM * Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.

Order new filter cartridges through the dealer where you bought the refrigerator, contact the Consumer Assistance Center at 1- 800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG-100 PureSource™* replacement cartridge.

The PureSource™ * NGRG-2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International, the nationally recognized and respected, not for profit, certification organization for public health safety.

The PureSource™* system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator.

The dispenser system will also operate without filtration (with filter cartridge removed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Open freezer door and leave open until filter change is complete.

2.Set ice maker wire signal arm to the OFF (up) position (See illustration on page 10).

3.Hold filter cup firmly, and unscrew towards left (Some water could leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.

4.Rinse out cup under running water.

5.The large o-ring that seals the filter system sets in the o- ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If

the o-ring becomes damaged, you will need to order one from the Consumer Assistance Center.

6.Discard old filter cartridge.

7.Remove new filter cartridge from packaging. Place in cup. The end with the small o-ring should be up, out of the cup.

8.Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do Not Tighten Past

Stop.

9.Set ice maker wire signal arm to the ON (down) position.

10.Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.

11.To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.

IMPORTANT

ResettingThe Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.

*White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Installation --Includes Connecting Solutions to Common ProblemsIce Maker To Water Supply Welcome & Congratulations Please Read and Save These InstructionsRegistration Card Included Withyour Important Safety Instructions Foryour SafetyChild Safety Proper Disposal Ofyour Refrigerator or FreezerInstallation Installation Connecting ICE Maker to Water Supply Before Installing The Water Supply Line,You Will NeedTo Connect Water Supply Line To Ice Maker Inlet Valve Door Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorFeatures AT a Glance Temperature Controls Temperature AdjustmentCool Down Period Refrigerator & Freezer ControlsLooking Inside Looking Inside Special Storage Areas Tall Bottle Retainer Some ModelsCrispers Some Humidity Control Some ModelsFeatures may vary according to model Automatic ICE and Water DispenserAutomatic ICE & Water Dispenser Operating Instructions Howthe Water Dispenser WorksICE and Water Dispenser Features Cleaning the ICE DispenserICE Dispenser Tips Remove and empty the ice storage bin ifPuresource TM * ICE and Water Filter Some Models System StartupChanging the Filter To change filterResetting The Filter Status Light some models PURESOURCE2TM * ICE and Water Front Filter Some ModelsFood Storage & Energy Saving Ideas Normal Operating Sounds & Sights Care & Cleaning Replacing Light Bulbs Warranty Information ConsumerTemperatures are TOO Cold Before YOU CallRunning of Refrigerator OPENING/CLOSING of DOORS/DRAWERSTemperatures are TOO Warm WATER/MOISTURE/FROST Inside RefrigeratorWATER/MOISTURE/FROST Outside Refrigerator Automatic ICE MakerICE Dispenser Water Dispenser Odors in RefrigeratorOPENING/CLOSING of DOORS/DRAWERS Light Bulb is not on

FRS26FCDB0, FRS26FCDB3, FRS26FCDB5, FRS26FCDB4, FRS26FCDB6 specifications

The Frigidaire FRS23F4CQ0, FRS6R4EB1, FRS3R4EQ0, FRS6R5EMB3, and FRS3R4EW0 are popular refrigerator models that offer a combination of reliability, functionality, and modern design. These models cater to various consumer needs while providing a range of innovative features and technologies.

One of the standout features across these Frigidaire models is the SpaceWise Organization System, which allows users to customize the interior storage space. This system includes adjustable shelves, door bins, and specialized compartments that can easily accommodate larger items. The full-width freezer drawers facilitate easy access to frozen goods, minimizing the hassle of searching for items tucked away in the back.

Another significant characteristic is the adjustable Temperature Control system. This feature enables users to set and maintain the optimal temperature for fresh food and frozen items. With the additional MaxCool setting, users can quickly lower the temperature in the refrigerator to preserve the freshness of food items during loading.

The Frigidaire refrigerators also emphasize energy efficiency, featuring ENERGY STAR certification. This ensures that they operate with reduced energy consumption, contributing to lower utility bills while being environmentally friendly.

In terms of cooling technologies, these models often incorporate the Even Temp cooling system, designed to maintain an even temperature throughout the refrigerator. This technology minimizes temperature fluctuations, ensuring that food stays fresher longer. The addition of humidity-controlled crispers provides optimal storage conditions for fruits and vegetables, preventing spoilage.

The exterior design preferences are also addressed with a stainless steel finish, offering a sleek and modern look that complements any kitchen decor. Many models include easy-to-clean surfaces that resist fingerprints, maintaining an attractive appearance without constant upkeep.

Further enhancing user experience, the Frigidaire models feature quiet operation, minimizing noise levels, which is particularly advantageous in open-concept homes. The easy-to-read digital controls provide simple adjustability, ensuring that users can manage their fridge settings at their convenience.

In summary, the Frigidaire FRS23F4CQ0, FRS6R4EB1, FRS3R4EQ0, FRS6R5EMB3, and FRS3R4EW0 models offer a blend of innovative features, energy efficiency, customizable storage options, and robust cooling technologies. These refrigerators are designed to meet modern kitchen demands while enhancing overall usability and maintaining a stylish aesthetic.
Top Page Image Contents