Frigidaire FRS23F4CW4, FRS6R5EMB1 manual PURESOURCE2TM * ICE and Water Front Filter Some Models

Page 13

AUTOMATIC ICE AND WATER DISPENSER

PURESOURCE2TM * ICE AND WATER FRONT FILTER (SOME MODELS)

NOTE

If you purchased a refrigerator with a PureSource2TM * Ice and Water front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right front corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.

The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

Order new filter cartridges through the dealer where you bought the refrigerator, contact the Consumer Assistance Center at 1- 800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the FC-

100PureSource™* replacement cartridge.

The PureSource2TM* Ice and Water Filter System NGFC 2000 with the PureSource2TM* cartridge FC 100 is tested and certified by NSF International, the nationally recognized and respected, not for profit, certification

organization for public health safety. The PureSource2TM* Filter system is tested and certified to ANSI/NSF Standards 42 and 53. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every

6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the

filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Set ice maker wire signal arm to the OFF (up) position (See illustration on page 10).

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

NOTE

A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing. Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.

3.Pull the old filter cartridge straight out of the housing.

4.Discard the old filter.

5.Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out.

6.When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing.

7.Set the ice maker wire signal arm to the ON (down) position.

8.Fill a glass with water. As you are doing this, check for leaks at the filter housing. There will be noticable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. This is normal.

9.After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank.

IMPORTANT

Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10- 15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

*White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Solutions to Common Problems Installation --Includes ConnectingIce Maker To Water Supply Please Read and Save These Instructions Welcome & CongratulationsRegistration Card Included Withyour Foryour Safety Important Safety InstructionsChild Safety Proper Disposal Ofyour Refrigerator or FreezerInstallation Before Installing The Water Supply Line,You Will Need Installation Connecting ICE Maker to Water SupplyTo Connect Water Supply Line To Ice Maker Inlet Valve Door Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorTemperature Adjustment Features AT a Glance Temperature ControlsCool Down Period Refrigerator & Freezer ControlsLooking Inside Tall Bottle Retainer Some Models Looking Inside Special Storage AreasCrispers Some Humidity Control Some ModelsAutomatic ICE and Water Dispenser Features may vary according to modelAutomatic ICE & Water Dispenser Operating Instructions Howthe Water Dispenser WorksCleaning the ICE Dispenser ICE and Water Dispenser FeaturesICE Dispenser Tips Remove and empty the ice storage bin ifSystem Startup Puresource TM * ICE and Water Filter Some ModelsChanging the Filter To change filterPURESOURCE2TM * ICE and Water Front Filter Some Models Resetting The Filter Status Light some modelsFood Storage & Energy Saving Ideas Normal Operating Sounds & Sights Care & Cleaning Replacing Light Bulbs Consumer Warranty InformationBefore YOU Call Temperatures are TOO ColdRunning of Refrigerator OPENING/CLOSING of DOORS/DRAWERSWATER/MOISTURE/FROST Inside Refrigerator Temperatures are TOO WarmWATER/MOISTURE/FROST Outside Refrigerator Automatic ICE MakerICE Dispenser Odors in Refrigerator Water DispenserOPENING/CLOSING of DOORS/DRAWERS Light Bulb is not on

FRS26FCDB0, FRS26FCDB3, FRS26FCDB5, FRS26FCDB4, FRS26FCDB6 specifications

The Frigidaire FRS23F4CQ0, FRS6R4EB1, FRS3R4EQ0, FRS6R5EMB3, and FRS3R4EW0 are popular refrigerator models that offer a combination of reliability, functionality, and modern design. These models cater to various consumer needs while providing a range of innovative features and technologies.

One of the standout features across these Frigidaire models is the SpaceWise Organization System, which allows users to customize the interior storage space. This system includes adjustable shelves, door bins, and specialized compartments that can easily accommodate larger items. The full-width freezer drawers facilitate easy access to frozen goods, minimizing the hassle of searching for items tucked away in the back.

Another significant characteristic is the adjustable Temperature Control system. This feature enables users to set and maintain the optimal temperature for fresh food and frozen items. With the additional MaxCool setting, users can quickly lower the temperature in the refrigerator to preserve the freshness of food items during loading.

The Frigidaire refrigerators also emphasize energy efficiency, featuring ENERGY STAR certification. This ensures that they operate with reduced energy consumption, contributing to lower utility bills while being environmentally friendly.

In terms of cooling technologies, these models often incorporate the Even Temp cooling system, designed to maintain an even temperature throughout the refrigerator. This technology minimizes temperature fluctuations, ensuring that food stays fresher longer. The addition of humidity-controlled crispers provides optimal storage conditions for fruits and vegetables, preventing spoilage.

The exterior design preferences are also addressed with a stainless steel finish, offering a sleek and modern look that complements any kitchen decor. Many models include easy-to-clean surfaces that resist fingerprints, maintaining an attractive appearance without constant upkeep.

Further enhancing user experience, the Frigidaire models feature quiet operation, minimizing noise levels, which is particularly advantageous in open-concept homes. The easy-to-read digital controls provide simple adjustability, ensuring that users can manage their fridge settings at their convenience.

In summary, the Frigidaire FRS23F4CQ0, FRS6R4EB1, FRS3R4EQ0, FRS6R5EMB3, and FRS3R4EW0 models offer a blend of innovative features, energy efficiency, customizable storage options, and robust cooling technologies. These refrigerators are designed to meet modern kitchen demands while enhancing overall usability and maintaining a stylish aesthetic.
Top Page Image Contents