Frigidaire FRS23H5ASB3, FRS23KR4AW5, FRS23KR4AB5, FRS26HR4AB3 Changing the Filter, To change filter

Page 16

Automatic Ice and Water Dispenser

PureSource2TM * Ice and Water Front Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource2TM * Ice and Water front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right front corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.

The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

Order new filter cartridges through the dealer where you bought the refrigerator, or contact the Consumer Assistance Center at 1-800-944-9044. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the PureSource2TM * replacement cartridge.

The PureSource2TM* Ice and

Water Filter System NGFC 2000 with the PureSource2TM* cartridge FC 100 is tested and certified by NSF International,

the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource2TM* Filter system is tested and certified to ANSI/ NSF Standards 42 and 53. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 400 gallons

•Rated service flow - .5 GPM

•Maximum Rated Pressure - 100 PSI

•Maximum Operating Temp. - 100° F

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Set ice maker wire signal arm to the OFF (up) position (See illustration on page 13).

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

NOTE: A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing. Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.

3.Pull the old filter cartridge straight out of the housing.

4.Discard the old filter.

5.Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out.

6.When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing.

7.Set the ice maker wire signal arm to the ON (down) position.

8.Fill a glass with water. As you are doing this, check for leaks at the filter housing. There will be noticable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. This is normal.

9.After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank.

IMPORTANT: Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 240389305 Welcome & Congratulations Please Read and Save These InstructionsImportant Safety Instructions For Your SafetyChild Safety Proper Disposal of Your Refrigerator or FreezerInstallation Before Installing The Water Supply Line, You Will Need To Connect Water Supply Line To Ice Maker Inlet ValveDoor Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorFeatures At a Glance Refrigerator & Freezer Controls Temperature Adjustment Temperature ControlsCool Down Period Cantilever Shelf Adjustment To adjust cantilever shelvesLooking Inside ICE Cream Shelf Some ModelsDoor Storage Tall Bottle Retainer Some Models Adjustable Door BinsSpecial Item Rack Some Models Humidity Control Some Models Crispers Some ModelsDeli Drawer Some Models Meat Keeper Some ModelsAutomatic Ice and Water Dispenser Automatic ICE & Water Dispenser Operating InstructionsICE and Water Dispenser Features How the Water Dispenser WorksHow the Ice Dispenser Works ICE Dispenser TipsCleaning the ICE Dispenser Remove and empty the ice storage bin ifPureSource TM * Ice and Water Filter some models Changing the Filter To change filterFood Storage Ideas Food Storage & Energy Saving IdeasEnergy Saving Ideas Normal Operating Sounds & Sights Care & Cleaning Care & Cleaning ChartVacation and Moving Tips Replacing Light BulbsWarranty Information Refrigerator WarrantyBefore You Call OPENING/CLOSING of DOORS/DRAWERSProblem Cause DOORS/DRAWERSIce maker is not making enough ice WarmCause Correction RefrigeratorCANADA, Canadá

FRS26HR4AQ3, FRS23H5ASB3, FRS26HF7BB0, FRS23KR4AW5, FRS26HR4AB3 specifications

The Frigidaire FRS26HF7BW0, FRS26HR4AW3, FRS23KR4AB5, FRS26HR4AB3, and FRS23KR4AW5 are a collection of reliable side-by-side refrigerators known for their blend of functionality, style, and innovative features. These models are designed to cater to the needs of modern households while ensuring efficient refrigeration and freezing.

One of the prominent features of these Frigidaire models is their spacious interior, which provides ample storage options. The refrigerators come with adjustable shelves that allow users to customize the storage space according to their needs. With a combination of clear crisper drawers and fixed shelving, organization becomes easy and convenient, promoting an efficient kitchen environment.

Additionally, these refrigerators are equipped with the Advanced Filtration Technology, which ensures that the water and ice dispensed are free from impurities. This feature not only guarantees better-tasting water but also enhances the overall quality of drinks served from the refrigerator.

The exterior design of these Frigidaire models includes a water and ice dispenser, providing quick access to refreshing drinks. The models come with a stylish finish that complements various kitchen decors, seamlessly fitting into any home environment. The LED lighting featured inside brightens every corner, making it easier to locate items even in low-light conditions.

Energy efficiency is a key characteristic of the FRS series. These refrigerators are ENERGY STAR certified, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This certification indicates that they consume less electricity compared to standard models, helping homeowners to save on energy bills.

Another essential attribute is the Frost-Free Defrost System, which helps prevent ice buildup in the freezer compartment. This technology simplifies maintenance and ensures that users can access frozen items without hassle. Furthermore, the models are constructed with durable materials that promise longevity and reliability.

In terms of capacity, each model has been designed with family needs in mind, providing plenty of room for groceries and larger items like party platters or bulk purchases. The thoughtful arrangement of shelves and bins helps to keep items organized and easily accessible.

In summary, the Frigidaire FRS26HF7BW0, FRS26HR4AW3, FRS23KR4AB5, FRS26HR4AB3, and FRS23KR4AW5 refrigerators stand out for their user-friendly features, energy efficiency, and spacious interiors. They embody Frigidaire's commitment to quality and innovative technology, making them an excellent choice for any home looking to enhance their kitchen experience.
Top Page Image Contents