Frigidaire 318200920 important safety instructions Avoid Service Checklist, Occurrence

Page 12

Avoid Service Checklist

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

Oven Control Beeps and Displays -F1- through -F10-.

Electronic control has detected a fault condition. Push CANCEL pad to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number, push the CANCEL pad and contact an authorized servicer.

-F8- is displayed.

The door was left open and controls set for self-cleaning cycle. Close the door and push both upper and lower oven CANCEL pads.

Installation.

Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if

 

rack and cabinet cutout flooring are not level.

 

 

 

Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are

 

square and level. Contact cabinet maker to correct problem.

Entire oven does not operate.

When the oven is first plugged in, or when the power supply to the oven has been interrupted, the display will flash. The oven cannot be programmed until the clock is set.

Be sure electrical cord is securely connected into the electrical junction box.

Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your dealer, installing agent or authorized servicer.

 

Service wiring not complete. Contact your dealer, installing agent or authorized servicer.

 

 

 

Power outage. Check house lights to be sure. Call your local electric company.

 

 

 

Short in cord/plug. Replace cord/plug.

 

 

 

Controls are not set properly. See instructions under Setting Oven Controls to set the

 

controls.

 

 

 

House fuse has blown or circuit breaker has tripped immediately following installation. House

 

fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.

 

 

 

House fuse has blown or circuit breaker has tripped after the oven has been

 

installed and previously operating. Call an authorized servicer.

 

 

Oven light does not work.

Burned-out or loose bulb. Follow the instructions under Changing Oven Light to replace or

 

tighten the bulb.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Wall Oven Product Registration Register Your ProductModel Number Serial Number Date Purchased Important Instructions for Using Your Oven Play around the applianceBefore Setting Oven Controls Setting Oven ControlsSelf Cleaning Ovens Important Instructions for Cleaning Your OvenOven Door Bracket Adjustment Some Side Swing Models Convection Cooking some modelsConvection Roasting some models Air Circulation in the OvenBaking Problems and Solutions Chart Oven BakingBroiling Oven Cleaning Cleaning the Self-Clean Oven some modelsAdhere to the Following Cleaning Precautions Preparing the Oven for Self-CleaningGeneral Cleaning To Clean the Oven BottomPorcelain Enamel Oven some models To Remove Heavy SoilGeneral Cleaning Cleaning Various Parts of Your applianceSurfaces How to Clean Adjusting Oven Temperature Changing Oven LightTo Replace Oven Door Hinge Slot Doorremovedfrom the rangeAvoid Service Checklist OccurrenceOccurrence Possible Cause / Solution Wall Oven Warranty Four encastré Enregistrement du produit Enregistrez votre appareilNuméro de modèle Numéro de série Date d’achat Mesures DE Sécurité Importantes Nutilisez pas lappareil pour entreposer des articlesInstallation des grilles Avant le réglage du fourRéglage du four Position de léventRéglage du support de la porte Rôtissage par convection certains modèlesCirculation de lair dans le four Certains modèles avec porte ouvrant sur le côtéCuisson au four Cuisson au gril Nettoyage du four Nettoyage du four autonettoyant certains modèlesPrenez les précautions de nettoyage qui suivent Préparation du four avant le cycle autonettoyantNettoyage du four suite Nettoyage du four en émail vitrifié certains modèlesNettoyage général Nettoyage des différentes parties de lappareilSurfaces Méthodes de nettoyage Réinstallation de la porte Nettoyage général suiteLampe du four Ajustement de la température du fourListe des vérifications préventives ProblèmeF8 est affiché Rien ne fonctionne dans le fourProblème Cause Possible / Solution Liste des vérifications préventives suiteGarantie DU Four Encastré
Top Page Image Contents