Frigidaire 318200650 manual Avoid Service Checklist, Occurrence Possible CAUSE/SOLUTION

Page 12

Avoid Service Checklist

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

Surface burners do not light.

Surface Control knob has not been completely turned to LITE. Push in and turn the Surface Control knob to LITE until burner ignites and then turn control to desired flame size.

Be sure gas supply valve is open.

Gas-air mixture needs a straight line to travel. Be sure burner is properly seated in its support (models with open burners only).

Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots.

Power cord is disconnected from outlet (electric ignition models). Be sure cord is plugged securely into outlet.

Electrical power outage (electric ignition models). Burners can be lit manually. See Setting Surface Controls in this Owner's Guide.

Surface burner flame burns half way around.

Burner ports or slots are clogged. With the burner off, clean ports with a small- gauge wire or needle to clean ports or slots.

Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry the burners thoroughly following instructions under General

Cleaning.

Surface burner flame is orange.

Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.

In coastal areas, a slightly orange flame is unavoidable due to salt air.

12

Image 12

Contents Gas Cooktop N e r ’ s I d e Contents Product RegistrationImportant Safety Instructions Important Safety Instructions TEMPERED-GLASS Cooktops some modelsLiquefied Petroleum Propane Gas Conversion Flame SizeGrounding Instructions electric ignition models only Flame Size Type of CookingProper Burner Adjustments Setting Surface ControlsSelecting Surface Cooking Utensils GoodCanning Tips Information Prevent damage to cooktop and burner gratesGeneral Cleaning Cleaning Various Parts of Your CooktopTo Raise and Lower the Top for Cleaning To Remove and Replace BurnersTo Remove Burners To Replace BurnersTo Clean the Cooktop To Clean the Contoured Burner PansTempered-glass Cooktop some models To Clean the Burner Cap To Replace the Burner Base and the Burner CapAvoid Service Checklist Occurrence Possible CAUSE/SOLUTIONCleaning Surface burner flame is orange Surface burners do not lightFrigidaire Cooktop Warranty Warranty for Canada GAS CooktopTable de cuisson à gaz Guide de Lutilisateur Enregistrement de lappareil ContenuEnregistrez votre appareil Pour Votre SécuritéMesures importantes de sécurité Mesures Importantes DE Sécurité suite Surface EN Verre Trempé certains modèlesDimension de la flamme Instructions de mise à la terreConversion au gaz propane Commandes des brûleurs de surface Bon réglage des brûleursEmploi du brûleur de surface Modèles avec allumeur électriqueBON MauvaisCasseroles et sous-plats particuliers Conseils et renseignements sur la mise en conserveNettoyage Général Nettoyage des diverses parties de votre table de cuissonRéinstallation des brûleurs Nettoyage général suiteSoulèvement ou abaissement du dessus pour lentretien Pour enlever et replacer les brûleursNettoyage de la surface de cuisson Nettoyage des grilles de brûleursNettoyage des cuvettes de brûleurs Nettoyage des couvercles de brûleursRemise en place de la base du brûleur et du couvercle Problème Cause POSSIBLE/SOLUTION Liste des vérifications préventivesLes brûleurs de surface ne sallument pas La flamme nest pas complète autour des brûleursGarantie pour le Canada Table DE Cuisson À GAZ