Frigidaire 318200650 manual To Clean the Burner Cap, To Replace the Burner Base and the Burner Cap

Page 11

General Cleaning (continued)

For Models with Sealed Burners (some models) (continued)

Burner Cap

 

Burner

Gas

Base

Opening

 

Electrode

 

Sealed Burner

 

To Clean the Burner Cap

Remove burner cap. Use soap-filled pad or mild abrasive cleanser to clean burner caps. If necessary, cover stubborn spots with an ammonia-soaked paper towel for 30 minutes. Rub gently with a mixture of clean water and vinegar. Wipe dry. Remove all cleaners or the porcelain may become damaged during future heating.

To Clean the Removable Burner Base and Gas Opening (some models) The ports (or slots) around the burner base must be routinely cleaned. Use a small- gauge wire or needle to clean small slots or holes.

Note: If the electrode is damaged or broken, the surface burner will not light because it will not spark. Manual lighting with a match is still possible.

For proper flow of gas and ignition of the burner - DO NOT ALLOW SPILLS, FOOD,

CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING TUBE. Gas must flow freely through the small hole in the brass orifice for the burners to light properly. If the gas opening orifice becomes soiled or clogged, use a small- gauge or needle to clean. ALWAYS keep the burner cap in place whenever a surface burner is in use.

To Replace the Burner Base and the Burner Cap

Make sure the pieces are thoroughly dry before placing back.

1.Replace burner base and burner cap at there place. Make sure each burner cap and burner base are properly aligned and leveled.

2.Replace the burner grate.

3.Turn the burner on to determine if it light. If the burner does not light after cleaning, contact an authorized servicer. Do not service the sealed burner yourself.

11

Image 11
Contents Gas Cooktop N e r ’ s I d e Product Registration ContentsImportant Safety Instructions TEMPERED-GLASS Cooktops some models Important Safety InstructionsFlame Size Type of Cooking Liquefied Petroleum Propane Gas ConversionFlame Size Grounding Instructions electric ignition models onlyGood Proper Burner AdjustmentsSetting Surface Controls Selecting Surface Cooking UtensilsPrevent damage to cooktop and burner grates Canning Tips InformationCleaning Various Parts of Your Cooktop General CleaningTo Replace Burners To Raise and Lower the Top for CleaningTo Remove and Replace Burners To Remove BurnersTempered-glass Cooktop some models To Clean the CooktopTo Clean the Contoured Burner Pans To Replace the Burner Base and the Burner Cap To Clean the Burner CapSurface burners do not light Avoid Service ChecklistOccurrence Possible CAUSE/SOLUTION Cleaning Surface burner flame is orangeFrigidaire Cooktop Warranty GAS Cooktop Warranty for CanadaTable de cuisson à gaz Guide de Lutilisateur Pour Votre Sécurité Enregistrement de lappareilContenu Enregistrez votre appareilMesures importantes de sécurité Surface EN Verre Trempé certains modèles Mesures Importantes DE Sécurité suiteConversion au gaz propane Dimension de la flammeInstructions de mise à la terre Modèles avec allumeur électrique Commandes des brûleurs de surfaceBon réglage des brûleurs Emploi du brûleur de surfaceMauvais BONConseils et renseignements sur la mise en conserve Casseroles et sous-plats particuliersNettoyage des diverses parties de votre table de cuisson Nettoyage GénéralPour enlever et replacer les brûleurs Réinstallation des brûleursNettoyage général suite Soulèvement ou abaissement du dessus pour lentretienNettoyage des couvercles de brûleurs Nettoyage de la surface de cuissonNettoyage des grilles de brûleurs Nettoyage des cuvettes de brûleursRemise en place de la base du brûleur et du couvercle La flamme nest pas complète autour des brûleurs Problème Cause POSSIBLE/SOLUTIONListe des vérifications préventives Les brûleurs de surface ne sallument pasTable DE Cuisson À GAZ Garantie pour le Canada