Architectural Series™
BPS - 1 I N - C E I L I N G S U B W O O F E R I N S T A L L A T I O N M A N U A L
3. Strip ¼” – ½” of insulation from each lead of the speaker wire. Twist the strands or tin the exposed wire with solder to ensure that there are no stray strands. (Stray strands that touch each other can cause a
4. The speaker’s positive connector post is labeled with a red dot; the negative post is labeled with a black dot (see Figure 13). Push the top of each connector post down to open the connector and insert the exposed wires into the holes in the posts. Double- check that you connected amplifier “+” to speaker “+” and amplifier
5. Once you have verified that the connections are correct, tighten the wire tie to secure the speaker cable to the
Figure 13: |
Installing the Architectural Finish Component
The Architectural Finish Component is installed after the ceiling is drywalled, finished and painted.
N O T E : F O R P A I N T I N G I N F O R M A T I O N , R E F E R T O T H E I N S T R U C T I O N M A N U A L I N C L U D E D W I T H T H E AR C H I T E C T U R A L FI N I S H CO M P O N E N T.
1. The
2. Insert about half of the Architectural Finish Component rim into the groove on the Adaptor Baffle. Gently fit the remaining half of the rim by working around the Baffle, fitting the rim into the groove as you go.
N OT E : F O R A P R O P E R I N S TA L L AT I O N T H E F O A M TA P E S H O U L D F I T S E C U R E LY A N D C O N S I S T E N T LY I N T O T H E G R O O V E I N T H E BA F F L E W I T H O U T B I N D I N G . IF N E C E S S A R Y, L I G H T LY L U B R I C AT E T H E FO A M TA P E W I T H W AT E R TO E A S E I N S E R T I O N.
Insert Finish Component Rim |
Into Groove Around Baffle |
Figure 14: Attaching the Architectural Finish |
Component To The Adaptor Baffle |
Page 6 of 8