General Cleaning (continued)
To Clean the Burner Grates, Contoured Burner Pans, Burner Caps and Burner Bases (continued)
To Clean the Burner Cap
Use a
To Clean the Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned. Use a small- gauge wire or needle to clean small slots or holes. Use care to prevent damage to the electrode. If a cleaning cloth should catch the electrode, it could break or damage the electrode. If the electrode is damaged or broken, the surface burner will not light. Manual lighting with a match is still possible.
For proper flow of gas and ignition of the
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Gas must flow freely through the small hole in the brass orifice for the burners to light properly. If the orifice gas opening becomes soiled or clogged, use a small- gauge wire or needle to clean. ALWAYS keep the burner base and the burner cap in place whenever a surface burner is in use.
Burner Cap |
| |
Burner | Gas | |
Base | ||
Opening | ||
| ||
Electrode |
|
To Replace the Burner Cap Assembly
Make sure all parts are dry before placing back on the burner.
1.Replace burner base at it place. Put back burner cap. Make sure each burner cap is properly aligned and level.
2.Turn the burner on to determine if it will light. If burner does not light after cleaning, contact an authorized servicer. Do not service the sealed burner yourself.
Cleaning the Self-Clean Oven (some models)
Adhere to the following cleaning precautions:
-Allow the oven to cool before cleaning.
-Wear rubber gloves when cleaning any exterior parts of the oven manually.
During the
The health of some birds is extremely sensitive to the fumes given off during the
Before cleaning any part of the oven, be sure the electronic oven control is turned off or else push CANCEL pad. Wait until the oven is cool.
DO NOT use commercial oven cleaners or oven protective coatings in or around any art of the
A
General 16 information