Frigidaire ES200/300 manual Adjusting Your Oven Temperature, Changing the Oven Light some models

Page 21

Care & Cleaning

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Please refer to the chart provided at the beginning of the Care & Cleaning section in this Use & Care Manual.

Changing the Oven Light (some models)

On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Manual.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Adjusting Your Oven Temperature

The temperature in the oven has been set at the factory. When first using the oven, be sure to follow recipe times and temperatures. If you think the oven is too hot or too cool, the temperature in the oven can be adjusted. Before adjusting, test a recipe by using a temperature setting that is higher or lower than the recommended temperature. The baking results should help you to decide how much of an adjustment is needed.

To Adjust Oven Temperature:

1.Press .

2.Set the temperature to 550°F (287°C) by pushing and holding the .

3.Within 2 seconds, press and hold until the special 2 digit display appears. Release . The display now indicates the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "00."

4.The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the or .

Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5. When you have made the desired adjustment, press to go back to the time of day display.

Note: The adjustments made will not change the self-cleaning temperature.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents
316257123 REV. a Register Your Product Welcome & CongratulationsImportant Safety Instructions Important Instructions for Usingyour Cooktop Features At a Glance Using proper cookware Before Setting Oven ControlsOven Vent Location Arranging Oven RacksAbout the Ceramic Glass Cooktop Element On and Hot Surface Indicator LightsAbout the Radiant Surface Elements Dual Radiant Surface Elements some modelsTo Operate Single Radiant Surface Elements Setting Surface ControlsSetting the Warming Zone Control some models Setting the Warming Zone ControlTo Operate Dual Radiant Surface Elements If equipped Oven Control Functions Temperature conversionTo Set the Minute Timer Setting Oven ControlsTo Change the Minute Timer while it is in use To Set the ClockTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout To Set Speed Bake Cooking System General Cooking InstructionsBenefits of Speed Bake Cooking System Decrease CookWhen the Set Bake Time Runs Out To Set the Timed Bake Feature some modelsRack Position From Top Food To BroilSelf-Cleaning Self-Cleaning OvenAdhere to the following cleaning precautions Stopping or Interrupting a Self-Cleaning Cycle To Start the Self-Clean Cycle To Set the Controls for a Self-Clean Cycle When the Self-Clean Cycle is CompletedSurfaces How to Clean Care & CleaningCleaning Recommendations for Ceramic Glass Cooktop Cooktop Cleaning and MaintenancePlastic or foods with a high sugar content For light to moderate soilRemoving and Replacing the Oven Door all models Cleaning Recommendations for Ceramic Glass CooktopsDo not use the following on the ceramic glass cooktop To Remove Oven DoorCare and Cleaning of Stainless Steel some models Adjusting Your Oven TemperatureTo Adjust Oven Temperature Changing the Oven Light some modelsBefore You Call Solutions to Common ProblemsAdjusting Oven Temperature in this Use & Care Manual Range Warranty
Top Page Image Contents